WiNECUBE LinkPod W2 Portable Charger User Guide
WiNECUBE LinkPod W2 Portable Charger

Product Introduction

Product Overview
Fully charge the product before first use
There are three output power modes switchable for portable power source.

  1. Once powering on, the default state of the product is express charging mode at up to 22.5w to meet the demand for quick charging;
    Charge Phone Or Device
  2. After powering on, double click to switch into output mode at up to 12w;
    Charge Phone Or Device
  3. After turning on the product, long-press button 3s to activate the Trickle-Charging mode. The power LED or display screen will start flashing. Click the button again to exit this mode. You can use Trickle-Charging mode to charge low-power devices.
    Charge Phone Or Device

Recharge your LinkPod W2

Recharge Your Linkpod

Pass through Charging

Pass through Charging
The power bank can charge other devices while it is being charged.

Specifications

Product Name: LinkPod W2
Model No.: LPW001
Capacity: 10000mAh(3.6V/36Whl
USB-C Cable/Port Input: 5V-34,9V-3A,12V-2.5A, 15V = 25, 20v = 1.54
Output: 5V = 36c = 3A_{1} 12v =2.56 * 15V = 2A, 20V = 1.5A
Lightning Output: 5V-2.4A
Wireless Charging. 5W
Size: 105.9 * 29.8 * 54.2mm
Weight: 205g

FCC Warning
This device complies with part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1)
this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur In a particular installation.

If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

  • Reorient or relocate the receiving antenna.
  • Increase the separation between the equipment and receiver.
  • Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
  • Consult the dealer or an experienced radio/TV technician for help.

The device has been evaluated to meet general RF exposure requirement. The device can be used in portable exposure condition without restriction.

KMK International Inc
Address: 9151 Fox Fire dr., Highlands Ranch, CO 80129, United States
Tel: +1-80 6099 6923

IVAN VOLENYUK KOROLYUK
Address: 24(medio), Calle Cadiz, 12006, Castellon de la Plana, Castelló, Spain
Email: ivanvolenyuk94@gmail.com
Tel: +34 662164290

RK Products Ltd:
Address: 35 BRAEMAR GARDENS LONDON POSTCODE: NWS SLB
Tel: +44 7944216897
Korea Office: 4.19-ro 13-gil, Ganbukgu, Seoul, Korea

Xiamen Jinkaiwei Electronics Co., Ltd.
Head Office/Manufacturer: Room 202, No. 153-9 Xingqian Road, Jimel, Xiamen, Fujian, China

Call Icon CN +86-400-8856-608 | Mon-Fri 09:00-17:00 Head Office +1 347 200 8459 | Mon-Fri 09:00-17:00
Email Icon 15396238219milsina.cn
Symbols

IMPORTANT SAFETY INSTRUCTIONS

Please make sure to notice the following reminder:

  1. The operating temperature of the product should be between O’C and 40°C/32’F and 104 deg * F
  2. DO NOT place the product near a fire source or in a high-temperature environment. Avoid placing it in a car, kitchen, bathroom, or any other high-temperature and high-humidity areas Exposure to fire or excessive heat may cause an explosion.
  3. DO NOT use the product if it has been submerged in water. Keep It away from rain and snow.
  4. Using chargers or charging cables not recommended or sold by the manufacturer, or those that do not meet local safety standards, may result in fire or injury.
  5. Ensure someone is present while charging the product. Unplug the power when going out or leaving for an extended period of time.
  6. DO NOT charge the product in places like bags, on beds, or sofas, as this can affect heat dissipation, Avoid covering it with dothing, bedding, or other items while charging.
  7. DO NOT let children use the product unsupervised. Close supervision is required when the product is used near children.
  8. DO NOT attempt to disassemble the product. For service or repairs, contact the manufacturer’s after-sales service. Incorrect disassembly or reassembly can cause fire or injury.
  9. The product may become hot during use, which is normal. Limit contact with high-temperature areas to less than 10 seconds.
  10. The product contains a built-in lithium battery. Be aware of the risk of fire and bums. DO NOT attempt to replace the battery yourself
  11. DO NOT disasserrible, strike, crush, or bum the product. If it swells, leaks, deforms, or overheats, stop using it immediately.

Warranty Card

Thank you for purchasing the product
This product provicles a one-year-warranty, and the sender will bear the freight respectively (The warranty starts from the receipt time confrmed by the express system of the order transaction)

Paid service:customer will incur a repair charge as follows:

  • No valid warranty card or warranty card incompatible
  • No S/N or S/N incompatible with warranty card
  • Malfunction caused by artificial damage el like external impact or submerging product into water, ect.)
  • Misuse of the product User has not followed the instructions in the manual.
  • Product disassembled or repaired by individual or unauthorized service center
  • Damages caused by storing the product in a hot or humid environment
  • Defects or malfunctions due to force majeure

Dealer’s Information

Deaker Name:….
Product Type:…..
Tel:…..
Sales Dute:…..

Users Information

Model No:…
Product Name: ….
User’s Name:…..
E-mail:…..
Tel:…..
ADDE:……
Warranty Content:……

Please complete warranty cord and use for any futures warranty service
WiNECUBE Logo

Documents / Resources

WiNECUBE LinkPod W2 Portable Charger [pdf] User Guide
LPW001, 2BQI6-LPW001, 2BQI6LPW001, LinkPod W2 Portable Charger, LinkPod W2, Portable Charger, Charger

References

Leave a comment

Your email address will not be published. Required fields are marked *