GT151 Throttle Controller
Throttle Controller GT151
Specifications:
- Model: GT151
- Compliance: FCC Part 15
- Conditions: Must not cause harmful interference, must accept
any received interference
Product Warranty Policy:
This device complies with part 15 of the FCC Rules. Operation is
subject to the following two conditions: (1) This device may not
cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause
undesired operation. Any changes or modifications not expressly
approved by the party responsible for compliance could void the
user’s authority to operate the equipment.
Product Usage Instructions:
Installation:
- Ensure the vehicle is turned off and parked safely.
- Locate the throttle controller unit in the vehicle cabin.
- Connect the throttle controller according to the provided
wiring diagram. - Securely mount the throttle controller in a convenient and
accessible location.
Operation:
Once installed, turn on the vehicle ignition and follow the
instructions to calibrate the throttle controller. Adjust the
settings to your preference for an optimized driving
experience.
Maintenance:
Regularly check the connections and ensure the throttle
controller is securely attached. Clean the unit with a dry cloth as
needed to maintain optimal performance.
FAQ:
Q: What should I do if the throttle controller is not
responding?
A: Check the wiring connections and ensure they are properly
secured. If the issue persists, refer to the troubleshooting
section in the user manual or contact customer support.
Q: Can I install the throttle controller myself?
A: While installation is possible for those with experience in
automotive electronics, it is recommended to seek professional
installation to avoid any potential issues.
Throttle Controller GT151
Product Warranty Policy
P Product Warranty Policy
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
Any Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: -Reorient or relocate the receiving antenna. -Increase the separation between the equipment and receiver. -Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. -Consult the dealer or an experienced radio/TV technician for help. FCC Radiation Exposure statement The device has been evaluatec to meel general RF exposure requirement. The device can be used in portable exposure condition without restriction.
Documents / Resources
 |
WIND BOOSTER GT151 Throttle Controller [pdf] User Manual 2BQR2-GT151, 2BQR2GT151, gt151, GT151 Throttle Controller, GT151, Throttle Controller, Controller |