WEILAN WL4BACTRL Remote Controller
Remote controller
The remote controller is an innovative one-handed visual range remote control designed to provide an exceptional robot manipulation controlling experience. Aiks is equipped with advanced robotic joints for superior mobility and responsiveness. This one-handed controller allows you to manipulate operate Aiks flexibly and quickly, bringing you an unparalleled unique joy.
Buttons Instruction
Pair with the controller upon first use
Procedure for Connecting Aiks with the Fingertip Control
- Keep the distance between Aiks and the control within 1m.
- With the battery charged and the device powered off, press and hold the power button on the right side for 5 s.
- Release the button until the blinking blue LED indicator stays on.
After they are connected for the first time, the control memorizes your Aiks and automatically reconnects to it every time you power on the control.
Use the controller
Once paired with Aiks, the controller automatically memorizes the information of Aiks. After that, every time you turn it on within 5 meters from Aiks, it connects to Aiks automatically with no need to pair again. You can use the controller to control the motions of Aiks instantly.
*Note: The effective working range of the controller is 5 m. In an open area, the control range can reach 10 m. The controller may be disconnected from Aiks if there are people moving around or metal obstacles, which seriously disturb the signal transmission. When the controller is within the minimum communication range (5 m, which can be prolongedup to 10 m in open areas) from Aiks, it automatically connects to Aiks again.
FCC Warning
This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any inte rference received, including interference that may cause undesired operation.
Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interferenceto radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Radiation Exposure Statement
The device has been evaluated to meet general RF exposure requirement. The device can be used in portable exposure condition without restriction.
Documents / Resources
 |
WEILAN WL4BACTRL Remote Controller [pdf] User Manual WL4BACTRL, WL4BACTRL Remote Controller, Remote Controller, Controller |
