Weego JS18 PROFESSIONAL Jump Starter Battery
Thank you for choosing Weego Jump Starter model JS18. Always follow basic safety precautions when using electronics or jump starting a vehicle. Read all instructions carefully. Please keep this Quick Start Guide for easy reference or you can download an electronic copy at www.myweego.com/support.
Weego At A Glance
Quick Start Guide – Ready, Get Set, Jump Your Vehicle!
BEFORE JUMP STARTING YOUR VEHICLE
- For 12V Vehicles ONLY! Do not use with any other system (6V, 24V, etc.)
- Read vehicle owner’s manual: The vehicle manufacturer may have specifi cautions and instructions about jumping your vehicle of which you should be aware.
- Put your vehicle in PARK and engage the emergency break.
- Turn off ALL electronics in your vehicle (air conditioner, heat, radio, lights, chargers, etc.) to ensure optimal performance of your Weego and safety of your electronics.
- Remove any and all USB and/or charging devices connected to your Weego.
- Make sure the vehicle battery terminals, jumper cables and Weego unit are free of any moisture.
Weego At A Glance
Quick Start Guide – Ready, Get Set, Jump Your Vehicle!
JUMP STARTING YOUR VEHICLE
- Ensure key is in the “OFF” position in the ignition. For smart-key fobs (pushto-start vehicles), make sure the vehicle is completely “OFF” before jump starting.
- Identify the positive and negative terminals on your vehicle’s battery. The positive terminal will usually be labeled with a (+) and/or red coloring.
- Do not attach clamps to Weego yet! First, securely attach the black clamp to the vehicle’s negative (-) battery terminal, then the red clamp to the vehicle’s positive (+) battery terminal. Be sure to adjust your clamps to achieve MAXIMUM contact on both sides of the clamps. Clamp connection is a ‘good, better, best’ scenario — a poor or miniscule connection will prevent you from starting your engine.
- Make sure your Weego is OFF.
- Securely fasten the clamps into your Weego. Check that you have a secure connection between the terminals and clamps, and between the clamps and Weego. Check the lights on the clamps:
- IF RED LIGHT IS ON AND ALARM SOUNDS: You have connected the clamps to the wrong terminals. Please reread and follow step 3. DO NOT PRESS “BOOST”!
- IF GREEN LIGHT IS ON: Your battery is still at a healthy level. DO NOT PRESS “BOOST”.
- IF GREEN LIGHT IS BLINKING AND ALARM SOUNDS: Your battery is at a low, unhealthy level. You will need to press “BOOST” to jump start your vehicle.
- IF NO LIGHT IS ON: You either have a poor connection, or your battery is extremely low. Recheck all connections. If still no light appears, press “BOOST”.
- Place your Weego in a secure location so it will not fall when starting the vehicle.
- Power ON your Weego. Start your vehicle.
- If after 3 seconds engine does not start, turn key to OFF position.
- Detach your Weego from the clamps. Wait 60 seconds and then follow steps 1-7. If problems still persist, please see the Troubleshooting section in your Weego Owner’s Manual for other possible causes.
- After a successful start, quickly detach your Weego from the clamps.
- Detach the clamps from the vehicle’s battery.
- You are now able to drive your vehicle. You should be sure to run your vehicle for at least 15 minutes before shutting it off again.
Documents / Resources
 |
Weego JS18 PROFESSIONAL Jump Starter Battery+ [pdf] User Guide JS18 PROFESSIONAL Jump Starter Battery, JS18 PROFESSIONAL, Jump Starter Battery, Starter Battery, Battery |
 |
Weego JS18 PROFESSIONAL Jump Starter Battery+ [pdf] Owner's Manual JS18 PROFESSIONAL Jump Starter Battery, JS18 PROFESSIONAL, Jump Starter Battery, Starter Battery, Battery |
