Wayfair Wrong Studio Vanity Table Instruction Manual

VANITY TABLE
INSTALLATION MANUAL

Wrong Studio Vanity Table

This is a unified installation manual of the 918s (small-sized) vanity table, suitable for three versions: simple, basic, and luxury.

Simple version: without mirror light, built-in socket, and hair dryer bracket; therefore, there is no mirror light power plug, built-in socket(K), and hair dryer bracket(L) in the accessories.
Basic version: with mirror light, without built-in socket, hair dryer stand. Therefore, there is no built-in socket(K) and hair dryer stand(L) in the accessories
Luxury version: with mirror light, built-in socket, hair dryer stand; therefore, all illustrated accessories are included.

Also note that:

1. Every hole on every board is useful; either a nut needs to be inserted or a screw needs to be inserted, and no hole is redundant.
2. There are marked points where the track needs to be fixed. Please use screw D to fix the track at the marked points.
3. Screw C is a drawer positioning pin to prevent the drawer from falling out when opened. Please confirm that all positioning screws C have been installed when the installation is completed.

Before installation, please find a marker pen with erasable marks, distinguish each accessory based on the shape of the board and the position of the holes, and then write the corresponding number on the board.

HARDWARE

1. Screw installation method
   When the screw is installed, please keep it in line with the board, and do not tighten it too tightly
2. Check the Nut direction
   This direction of the marked nut is consistent with the direction in which the scre is insertedThis hole is for inserting the screw
3. Installation on the board with fixing screws
4. Rotate slowly until it stops

If your vanity table includes an LED mirror light, please test the light in this step. Touch the switch botton on the mirror to turn on the mirror light, click the switch botton to change the color of the light, and long press the switch botton to adjust the brightness. If the switch botton is not sensitive, you can check whether the touch switch is tightly attached to the mirror back as shown in the diagram. If it is not tightly attached, please use your fingers to press the touch switch to the designated position and check if the connecting wire is OK.

Please note that when placing the drawer in, the drawer positioning pin will block the drawer. Therefore, please follow the diagram to first insert the inner edge of the drawer using a concave method, and then push the drawer flat.

Only for a vanity table with a hair dryer bracket and a built-in socket

Only for a vanity table with a hair dryer bracket and a built-in socket