wayfair Counter Table Set Installation Guide

wayfair Counter Table Set

Quick Setup & Use

• Before unpacking, read the instructions thoroughly; remove any exposed staples used in packing.
• Assemble with another person to make assembly easier and help prevent product damage or injury.
• Check packing materials carefully for small parts that may have loosened during shipment.
• Place all parts on a non-abrasive floor before assembly and follow the steps provided.
• Do not fully tighten any bolts until the last step.
• Stool: follow Step 1 (“Stool Construction”) to assemble the stool components.
• Table: in Step 2 (“Connecting the Frame”), tighten the full-tooth bolt fully first, then connect the middle stretcher.
• Secure the desktop in Step 3.
• In Step 4 (“Final Cover Placement”), assemble remaining parts and use the lip (14) to cover the access hole.
• During assembly, do not over-tighten screws or bolts; fully tighten at the final step.

Caution: Please read instructions thoroughly before unpacking assembly parts. Sharp, exposed staple tips can cause injury; therefore, for your protection, please remove any exposed staples used in packing.

1. We recommend that you assemble this product with the assistance of another person; this will make assembly easier and will help to eliminate damage to the product or injury to persons during assembly.
2. Be sure to check all packing materials carefully for small parts that may have come loose inside the carton during shipment.
3. Please do not overtighten screws or bolts.
4. Please put all parts on a non-abrasive floor before assembly, and follow the assembly steps to assemble your newly purchased product correctly and efficiently.

PART LIST

NOTES: Do not fully tighten any bolts until last step

HARDWARE LIST

• TOOLS REQUIRED (NOT PROVIDED)
• Phillips Screwdriver

Assembly Instructions

STEP 1

COMPLETED

STEP 2

• Please tight full tooth bolt full the first, after to connect the middle stretcher.

STEP 3

STEP 4

• Assemble all of parts. Please use the lip (14) to cover the hole.

COMPLETED

WARRANTY

WARRANTY CARD

Your warranty includes

• 30 Days Money Back Guaranty
  Within the first 30 days of your purchase, you are allowed to retum your product for a full refund.
• 30 Days to 3 Months(6 Months)
  We will replace the defective unit due to manufacturer fault with a new one. (You will receive an extra 3-month warranty if you register on our website.)
• 3 Months to 24 Months
  Within 24 Months, we will provide timely and effective online after-sales service after your purchase.

How to return your Products

• We will issue γou RMA # and return address for your return.
• Please fill out the RMA info, tear off this page, and leave it inside γour return pαckage.
• We will issue replace I return after receiving your return.

Return product details

• To get your returns processed as qυicklγ αs possible, please fill out this form and include it in your return packαge.

• If your product was purchased through an oficial fulfillment channel, please contact the platform’s customer service to request a return within 30 days of purchase.

Troubleshooting

• Bolts feel difficult to tighten or look misaligned: ensure you have followed the note not to fully tighten bolts until the last step, then proceed to final tightening after all steps are complete.
• Missing small parts after unpacking: re-check the packing materials carefully for small parts that may have come loose inside the carton during shipment.
• Hardware seems over-tightened: do not over-tighten screws or bolts; loosen and re-adjust as needed, then tighten properly at the last step.
• Access hole not covered: confirm you used the lip (14) to cover the access hole during the final cover placement step.