WARSTAR ST7 PRO Flashlight User Manual

WARSTAR-logo

WARSTAR ST7 PRO Flashlight

WARSTAR-ST7-PRO-Flashlight-product

Specifications

  • Brand: WARSTAR
  • Model: ST7 PRO
  • Product Type: Multi-function EDC / Work Flashlight
  • Main Light Output: Up to 2,200 lumens
  • Main LED: 2 × SFT25 15W LEDs
  • Color Temperature: 6500–7500K
  • Beam Distance: Up to 426 m
  • UV Light: 365 nm UV LED
  • Laser: Class 3R green laser, 5 mW
  • Laser Range: Up to 980 m
  • Ambient Light: RGB side light
  • Brightness Modes: 5 levels with stepless dimming
  • Battery: Rechargeable Li-ion
  • Battery Capacity: 1,600 mAh
  • Charging Port: USB Type-C
  • Charging Input: 5V / 2A
  • Charging Time: Approximately 3 hours
  • Main Light Runtime: Up to 15 hours on Low; about 6.5 hours on High
  • UV Runtime: Approximately 6.2 hours
  • Laser Runtime: Approximately 62 hours
  • Material: Aircraft-grade aluminum alloy
  • Water Resistance: IP56
  • Impact Resistance: Up to 1 m
  • Mounting: Built-in magnetic base and two-way clip
  • Controls: Rotary switch; double-click for Turbo
  • Applications: Camping, outdoor activities, vehicle repairs, inspection, emergency use and EDC

Quick Setup & Use

  1. Connect a standard USB-C charging cable to begin charging (full charge is approx. 2 hours).
  2. After fully charged, disconnect the cable to help extend battery service life.
  3. To turn the flashlight on, press and hold the power button for 3 seconds.
  4. To switch modes, use a single short press to cycle: High Brightness → Low Brightness → Strobe / SOS Emergency Mode.
  5. To turn the flashlight off, press and hold the power button for 3 seconds.
ST7 PRO FLASHLIGHT USER MANUAL

Important Operation Guide

This flashlight adopts a long-press anti-misoperation design to avoid accidental lighting in pockets.

Power On & Off

  • Press and hold the power button for 3 seconds to turn ON
  • Press and hold the button again for 3 seconds to turn OFF

Note: A short single click cannot activate the light.

Light Mode Switch (After power on)
Single short press to cycle through modes: High Brightness → Low Brightness → Strobe / SOS Emergency Mode

Charging Instructions

  • Flip open the Type-C rubber dust cap and connect a standard USB-C charging cable.
  • Full charging time: approx. 2 hours
  • Disconnect power after fully charged to extend battery service life.
  • Built-in power indicator displays remaining battery level.

Safety Warning

  1. Do not stare directly at the light beam; strong light will cause eye damage.
  2. Do not cover the lamp head during use; high temperature may trigger fire risk.
  3. Store away from high-temperature environments (over 50°C / 122°F).
  4. Unauthorized disassembly voids all warranty services.

Maintenance

  • Clean the flashlight lens and body regularly with a soft, dry cloth.
  • Keep the USB-C charging port free from dust, dirt, and moisture.
  • Do not charge the flashlight when the charging port or cable is wet.
  • Use a compatible USB-C charging cable and power source.
  • Avoid dropping the flashlight or exposing it to unnecessary impacts.
  • Keep the flashlight away from extreme heat, flames, and prolonged direct sunlight.
  • Do not disassemble the flashlight or rechargeable battery yourself.
  • Check the O-rings and seals periodically for dirt, damage, or wear to help maintain water resistance.
  • If the flashlight has been exposed to water, dry it thoroughly before charging.
  • Clean the UV lens and laser/light-emitting areas gently without abrasive materials.
  • Avoid looking directly into the laser or high-intensity LED beam.
  • If the flashlight will not be used for an extended period, store it in a cool, dry place with the battery partially charged.
  • If the battery becomes swollen, unusually hot, leaks, or shows other signs of damage, stop using and charging the flashlight immediately.

Troubleshooting

  • Light won’t turn on: use a press-and-hold for 3 seconds. A short single click cannot activate the light.
  • Charging issues / unclear charging progress: confirm the Type-C rubber dust cap is open, and the cable is connected properly to a standard USB-C charger. Check the built-in power indicator for remaining battery level.
  • Reduced runtime after charging: disconnect power after the battery is fully charged (approx. 2 hours) to help extend battery service life.

Documents / Resources

PDF thumbnailST7 PRO Flashlight
User Manual · 5c9f338f076d1a2b9dab9996418f6848, ST7 PRO Flashlight, ST7 PRO, Flashlight

References

Ask a Question

Use this section to ask about setup, compatibility, troubleshooting, or anything missing from this manual.

Ask a Question

Ask about setup, compatibility, troubleshooting, or anything missing from this manual. Name and email are optional.