Warmrails FBA WHC Hyde Park Towel Warmer Chrome
SAFETY INFORMATION
When using any electrical appliance, basic safety precautions should always be observed.
READ THESE INSTRUCTIONS CAREFULLY
- Do NOT use this appliance for other than its intended use.
- To avoid a hazard, the Heated Towel Stand MUST NOT be used to hold towels or any other articles that have been in contact with oil, petroleum-based products, or dry cleaning fluids.
- Use this appliance only on the voltage specified on the rating plate, or elsewhere in the instructions.
- Regulations require that only authorized persons carry out electrical work. For your own safety and that of others, ensure this is done.
- Do NOT store your Heated Towel Stand while hot or still connected to the power supply.
- Do NOT immerse the Heated Towel Stand in water or any other liquid.
- Do NOT allow the cord set to come into contact with heated surfaces during operation.
- This product should NOT be used outdoors.
If the power supply cord for this equipment becomes damaged it must be replaced with a special cord or assembly. Special tools are required for the replacement of the power supply cord and element. A qualified electrician must undertake this replacement.
WARNINGS
HIGH OPERATING TEMPERATURE:
- This towel warmer operates at high temperatures that can cause burns.
- Do not touch the surfaces of the towel warmer while the warmer is in operation.
- Do not allow unsupervised children in the vicinity of the towel warmer, and warn children of hot surfaces.
TO AVOID THE POSSIBILITY OF ELECTROCUTION:
- Do not immerse the towel warmer in water or any other liquid.
- Do not place the towel warmer in a location where it may fall into a tub or shower, or otherwise become Immersed in water; and if the towel warmer falls into water, immediately unplug it. Do not reach into the water.
SPECIFICATIONS
ASSEMBLY
This appliance must be used in accordance with any prevailing electrical code and relevant electrical wiring rules and regulations and in particular those regulations that cover the use of appliances and accessories in damp situations such as bathrooms, showers, laundries, and other areas with fixed water containers.
- Your Warmrail comes complete with two long bolts and an Allen key which you will find in a small plastic bag. Use the bolts to secure the base to the Heated Towel Stand.
- To assemble, first, remove the long bolts and Allen key from the plastic bag
- Hold the Heated Towel Stand upside down (perhaps leaning it against a chair) and position the base so that the bolt holes line up with the two vertical bars of the Heated Towel Stand.
- You will notice that the bolt holes on the base are off-center. For stability, the stand should be positioned so that it is attached towards the back of the base (ie with the largest part of the base to the front of the towel stand). You will also notice that Hyde Park is curved, and the correct way to face the unit is so that as you look at it, the power cord comes out of the right-hand side.
- Insert one bolt through each hole and use the Allen key to tighten.
- The Hyde Park Freestanding Heated Towel Stand must only be used with the base properly fitted.
- Once the base is securely attached, the Heated Towel Stand can be plugged into an electrical outlet (we recommend using a GFI-protected outlet). Push the on/off switch so that the light is illuminated and vour Warmrail is ready for use.
- Remember, Warmrails are so energy efficient, you can leave them running continuously.
OPERATION
To operate, push the switch on the end of the Towel Stand by the cord set. It will be illuminated when on and will be dull when off.
- Your Warmrail Heated Towel Stand costs less or is similar to running to a regular light bulb. It will take approximately 45 minutes for the Heated Towel Stand to reach its operating temperature, although this time will be shorter if towels are in place.
- The Warmrails Heated Towel Stand operates with a fixed power output. However, when operated with several layers of towels over the Heated Towel Stand, the temperature will increase. Once the towels are removed and where the rails are exposed, the temperature of the Heated Towel Stand will quickly drop back.
Please note:
Damp or wet material that has either been dyed or is not colorfast, can cause discoloration in the finish if that material is draped over a Heated Towel Stand while hot. Again, it is suggested that items are dried by using a completely protective layer of material such as a towel underneath.
Warning
This appliance is intended only for drying textiles washed in water. Fabrics that contain soap or detergent residue may show what appear to be scorch marks. However, this is simply the discoloration of the residue.
Warmrails does not accept responsibility for any damage, discoloration, or other damage to any item regardless of circumstance. To reduce the possibility of damage, do not place any items other than towels directly on the Heated Towel Stand–always have a completely protective layer of towels between the Heated Towel Stand and any other item.
CARE
- The Heated Towel Stand should be wiped down from time to time with a damp cloth.
- Do not use any abrasive or corrosive cleaners.
Marketed and Distributed by
SEEOALL
- 3623 South Laflin Place, Chicago, IL 60609
- Toll-free: 800.873.1313
- FAX: 773.927.7742
- www.seeall.com.
Documents / Resources
 |
Warmrails FBA WHC Hyde Park Towel Warmer Chrome [pdf] Instruction Manual FBA WHC Hyde Park Towel Warmer Chrome, WHC Hyde Park Towel Warmer Chrome, Hyde Park Towel Warmer Chrome, Park Towel Warmer Chrome, Towel Warmer Chrome, Warmer Chrome, Chrome |
