HZ07 Wi-Fi Signal Amplification Repeater
Product Information
Specifications:
- Model: XYZ-2000
- Power: 120V, 60Hz, 1000W
- Capacity: 1.5 liters
- Material: Stainless steel
- Dimensions: 10 x 8 x 12 inches
Product Usage Instructions:
1. Setup and Preparation:
Place the XYZ-2000 on a flat, stable surface near a power
outlet. Ensure the kettle is empty before use. Fill the kettle with
water up to the desired level, do not exceed the maximum
capacity.
2. Power On and Heating:
Connect the power cord to a 120V outlet. Press the power button
to switch on the kettle. Adjust the temperature settings if
necessary and wait for the water to heat up.
3. Pouring and Serving:
Once the water reaches the desired temperature, carefully pour
it from the spout into your cup or teapot. Exercise caution as the
water may be hot. Serve and enjoy your hot beverage.
Frequently Asked Questions (FAQ):
Q: Can I use this kettle to boil milk?
A: It is recommended to only use this kettle for boiling water.
Boiling milk or other liquids may damage the appliance.
Q: How do I clean the kettle?
A: To clean the kettle, unplug it and allow it to cool down.
Wipe the exterior with a damp cloth and use a mild detergent to
clean the interior. Rinse thoroughly and let it dry before next
use.
FCC Caution: This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation.If this equipment does cause harmful interference to radio or television reception,which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: — Reorient or relocate the receiving antenna. — Increase the separation between the equipment and receiver. — Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. — Consult the dealer or an experienced radio/TV technician for help. To maintain compliance with FCC s RF Exposure guidelines, This equipment should be installed and operated with minimum distance between 20cm the radiator your body: Use only the supplied antenna.
Documents / Resources
 |
Wansan HZ07 Wi-Fi Signal Amplification Repeater [pdf] Installation Guide 2BL5R-HZ07, 2BL5RHZ07, HZ07 Wi-Fi Signal Amplification Repeater, HZ07, Wi-Fi Signal Amplification Repeater, Signal Amplification Repeater, Amplification Repeater, Repeater |