waev 2BFMW Bar Display
Product Image
- 7” Display
- 7200mAn bakery
- Charger stand
How to use
- Plug to battery pack into Bar Display.
- Power on, the top LED will turn green.
- Will continue to autorun the advertisements.
- Phone charging via USB Type A & USB Type C ports.
- Power off, remove the battery.
- Charging Battery.
FCC
Federal Communication Commission Interference Statement
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
FCC Caution: To assure continued compliance, any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate this equipment. (Example – use only shielded interface cables when connecting to computer or peripheral devices).
FCC Radiation Exposure Statement
This equipment complies with FCC RF radiation exposure limits set forth for an uncontrolled environment.
This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
- This device may not cause harmful interference, and
- This device must accept any interference received, including interference that may cause undesired operation.
FAQs (Frequently Asked Questions)
- Q: What type of battery does the Bar Display use?
A: The Bar Display comes with a 7200mAh battery. - Q: Can I charge my phone using the Bar Display?
A: Yes, you can charge your phone via the USB Type A & USB Type C ports on the Bar Display. - Q: How do I know if the device is powered on?
A: When the device is powered on, the top LED will turn green as an indicator.
Documents / Resources
 |
waev 2BFMW Bar Display [pdf] User Manual 2BFMW-20240220, 2BFMW20240220, 2BFMW Bar Display, 2BFMW, Bar Display, Display |
