vtech MPE1KB Key Switch User Manual

User manual
E-DRIVE key switch
MPE1KB

MPE1KB Key Switch

Make sure that the user of the vessel is supplied with the owner’s manual.

Safety

Warning indications
Where applicable, the following warning indications are used in this manual in connection with safety:
Danger
Indicates that great potential danger exists that can lead to serious injury or death.
Warning
Indicates that great potential danger exists that can lead to serious injury or death.
Caution
Indicates that the usage procedures, actions etc. concerned can result in serious damage to or destruction of the engine. Some CAUTION indications also advise that a potential danger exists that can lead to serious injury or death.
Note
Emphasises important procedures, circumstances etc

Symbols
Indicates that the relevant procedure must be carried out.
Indicates that a particular action is forbidden.
Pass on the safety instructions to others using the E-LINE motor.
General rules and laws concerning safety and accident prevention must always be observed.
Warning
This product should only be operated by persons who have read and understood the instructions and precautions in this manual. Failure to follow the instructions in this manual may result in serious injury or property damage. The manufacturer shall not be liable for any damages resulting from improper operation.

Introduction

This manual gives guidelines for the use of the VETUS MPE1KB E-DRIVE key switch.
Unauthorised modifications shall exclude the liability of the manufacturer for any resulting damage.

• During use ensure the correct battery voltage is available.

Warning
Changing over the plus (+) and minus (-) connections will cause irreparable damage to the installation.
Warning
Never work on the electrical system while it is energized.

Operation

3.1 Switch on
Make sure that the on-board power supply and the power supply of the V-CAN line are switched on.

• Open the locking cap and turn the key to the right to turn the power on. When the power is turned on, a blue LED will light up on the panel as an indication.

3.2 Switch off

• Turn off the power by turning the key to the left. When the power is turned off, the blue LED on the panel is not lit.
• Turn off the on-board power.

Copyright © 2024 VETUS B.V.
Schiedam Holland
Tel.: +31 (0)88 4884700
sales@vetus.com 
www.vetus.com
Printed in the Netherlands
370501.01 2024-07