VOYAGER 2T Voice Intercom
Product Information
Specifications
- Product Name: Voyager Voice Intercom
- Version: 1.0
- System Compatibility: GSM Intercom System
- Keypad: 4-digit codes
- Mobile App: Android and iPhone compatible
Product Usage Instructions
Granting Access
To grant access to an incoming call, follow these steps:
- For granting access, press * followed by 1 or * followed by 2 to trigger Output 1 or 2 respectively.
- This action will pulse the relay, allowing access.
Denying Access
To deny access to an incoming call:
- Press # to indicate no access.
- If further numbers are programmed, they will be called in a follow-up call.
- To terminate the call without granting access, press #.
Maintaining GSM Intercom System
Ensure to top up the SIM card at predefined intervals as networks require regular top-ups even on PAYG SIM cards.
Using the End User App
The End User App simplifies GSM Intercom usage:
- Scan the QR code matching your phone type to install the app.
- Set the phone number for communication by entering it in the app settings.
If you make a mistake while entering a code, press the * button to start again.
Frequently Asked Questions (FAQ)
- How do I know if my GSM Intercom system is working properly?
You can test the system by making a call and checking if you can grant or deny access as needed. - Can I use the End User App on multiple phones?
The End User App is designed for one user control per entrance assigned, so it is recommended to use it on one phone per entrance.
Using The Intercom
- On the mobile Phone, press * followed by 1 or * followed by 2 (to trigger Output 1 or 2) to grant access (this will pulse the relay).
- to NOT grant access terminate the call with #.
- Just hanging up the phone isn’t sufficient. If further numbers are programmed then these will be called in a follow on call. When not granting access, terminate the call by pressing #.
Maintaining your GSM Intercom System
- Bill Pay SIM: If you have a Bill pay SIM in your GSM Intercom system then you don’t need to worry about keeping credit on the SIM. This is by far the easiest and most reliable way to operate these devices. Please discuss this option with your installer and he may be able to direct you to get a good value bill pay SIM.
- Pay as You Go SIM (PAYG): If you are using a PAYG SIM in your GSM Intercom then you need to be aware of the requirement to keep credit on this SIM. Register the phone number with the network operator, ie Vodafone, O2, GiffGaff etc. and top up the SIM as required by the network. For some networks you pay for credit and use it as you go. But for most there is a monthly requirement to top up. Also remaining credit is removed at the end of each month.
Please note it is not sufficient to have credit on a PAYG SIM, the networks require that you top up the SIM at pre defined intervals.
Getting The End User App
- The End User App allows for simple use of the GSM Intercom. It allows one user control that entrance they have been assigned. Pass your camera over the QR image below, which matches the type of phone you have. When you reach the app page install it to your phone.
- To set the Phone number that the App is communicating with, press on the wheel and enter the Phone Number of your Intercom.
Using the Keypad.
- Using the keypad is simple. Codes are 4 digits
- Should you make a mistake when entering a code and need to start again, then simply press the Star button ( * ) as highlighted above to start again.
Documents / Resources
 |
VOYAGER 2T Voice Intercom [pdf] User Manual 2T Voice Intercom, 2T, Voice Intercom, Intercom |