VOW Elevons System User Guide

VOW Elevons System

Attaching Blocks to Mounts:

1. Use M5 x 30mm Flangehead bolts and track spacers.
2. Place the block in the desired position on the Bolt tracks.
3. Tighten the bolts “fingertight” with a manual screwdriver to prevent damage.

Mounts Overview

The VOW Elevons system has multiple mounts

Blocks Overview

The VOW Elevons system has numerous blocks

Attaching Blocks to Mounts

The blocks can be mounted to the bolt tracks individually using the appropriate bolts and spacers. Simply place the block in the appropriate position and tighten the bolts ‘fingertight’ with a manual screwdriver, not using much leverage. The blocks shouldn’t be able to move if the system is correctly tightened. Overtightening can damage the elevon blocks / bolt tracks

The Crossbar mounts to the Nyloc nuts inside the bolt tracks using the appropriate spacers and 16mm buttonhead M5 bolts. Blocks can then be bolted to the Crossbar using 30mm flange head M5 bolts with 5mm spacers The plate mounts to the footpad through the bumper and rail corner bolts on both the XR and GT frame (XR Pictured). The bolts used to mount the plate are simply extended over the stock size by approximately 8/10mm depending on the frame and plate type. Blocks mounts in the same way as the crossbar, using 30mm M5 flangeheads with 5mm spacers.

FAQ