VOLT VSPL-1048-BBZ Solar Motion Sensor Stemless Brass Path Light
IMPORTANT: PLEASE READ BEFORE INSTALLATION
This luminaire is intended for installation by local codes and the National Electrical Code (NEC). Failure to adhere to these codes and instructions may result in serious injury, property damage, and the voiding of the warranty.
These instructions do not intend to cover all installation, operation, maintenance or mounting variations.
Please note that this fixture is controlled by the built-in motion sensor and is equipped with built-in photocells, so it will not turn on until it is dark enough and movement is detected in certain areas. These fixtures will also require plenty of sunlight to function properly. It’s best to have the fixture in an area where the sun will get to it at all times throughout the day and where no ambient lighting will affect the photocell at night.
PACKAGE CONTENTS
- A. (1) Solar Light
- B. (1) Coupler
- C. (1) Stake
- D. (1) Screw
- E. (1) Coupling
- F. (2) Washer
- G. (1) Anchor
PRODUCT DIMENSION
TEST SOLAR LIGHT
Cover the solar panel completely with black material. Do NOT cover the motion sensor. When movement is detected in 5 meters at 150 degrees, the fixture will light on. And the fixture will turn off after 2 minutes automatically.
Proceed to the next steps of installation once you determine the fixture is functional..There are two installation options provided. Option 1: Stake for soft ground.
Option 2: Anchor and Screw for hard ground.
INSTALLATION OPTION 1
INSTALL STAKE TO SOLAR LIGHT
Thread the coupler into the bottom of the solar light. Thread the stake onto the coupler.
INSERT THE STAKE TO THE GROUND
Insert the stake into the ground until it is flush.
INSTALLATION OPTION 2
Insert the stake into the ground until it is flush.
INSTALL COUPLING TO GROUND
Drill a proper hole in the ground for the anchor. Insert the anchor into the drilled hole. Place the washer and the coupling onto the anchor and secure with the screw.
INSTALL SOLAR LIGHT TO COUPLING
Thread the solar light onto the coupling.
PRODUCT FUNCTION INSTRUCTIONS
- At dusk, the solar panel stops charging, and the motion sensor of the luminaire will be activated and light up when there is movement. The luminaire will automatically turn off after 2 minutes of no detected movement.
- At dawn, the luminaire will stop working and the solar,r panel will start charging the battery. In this state, the motion sensor will not be activated even if there is movement.
1-813-978-3700 Mon-Fri8 am8 pm Sat-S10 am0a6 pm 6 pm (EST)
Specifications and product details are subject to change without notice.
Copyright 2024, VOLT® Lighting, Lut,z, F L USA 33.549 All rights reserved.
customersupport@voltlighting.com
www.voltlighting.com
Documents / Resources
 |
VOLT VSPL-1048-BBZ Solar Motion Sensor Stemless Brass Path Light [pdf] Installation Guide VSPL-1048-BBZ, VSPL-1048-BBZ Solar Motion Sensor Stemless Brass Path Light, Solar Motion Sensor Stemless Brass Path Light, Motion Sensor Stemless Brass Path Light, Stemless Brass Path Light, Brass Path Light, Path Light |