VIZULO Pine Connect LED Linear Luminaire
Safety instructions
Any actions with the luminaire must be performed by a qualified person, who is certified according with national regulations and requirements.
- To prevent any accidents person installing the luminaire must follow national safety requirements and following instructions:
- The label containing technical parameters of the luminaire has to be studied before the work on it has begun.
- Any luminaire build or design changes are prohibited.
- The luminaire must be used in good technical condition and according with these instructions.
- Only VlZULO authorized spare parts and accessories can be used to repair the luminaire.
- The repair of luminaire has to be performed by a qualified and certified person.
Terms of use and maintenance
Before luminaire is turned on, it should be mounted according with these mounting instruction or any other applicable regulations.
Mounting instructions
Mounting of luminaire must be performed by a qualified person according to following instructions:
- The warranty of luminaire does not apply, if the mounting of the luminaire has been performed in precipitation (rain, snow, hail).
- The warranty of luminaire does not apply, if an unauthorized control system by VIZULO or an inapplicable LED driver has been used to drive the luminaire.
- The warranty of luminaire does not apply, if it has been used in an unsuitable ambient temperature or has been supplied by voltage outside of the specified range.
- The warranty of luminaire does not apply, if the LED driver program has been changed in any way.
- The warranty of the luminaire does not apply, if the logged history data of the LED driver has been deleted without the permission of VlZULO.
- The warranty of luminaire does not apply, if it has been mounted an unspecified angles or upside down (luminaire glass directed up), or it has been completely submerged under water.
Maintenance and repair
Luminaire has to be disconnected from electrical grid before it is opened and/or repaired!
- The person working with the luminaire must follow national regulations and legislation that apply to maintenance and testing of electrical or electronic appliances.
- The luminaire may need to be cleaned depending on its environment. Only a damp cloth or a sponge may be used to clean the luminaire. Use only household detergents diluted by water.
- Only VIZULO authorized spare parts may be used for the luminaire.
- Instruction for changing spare parts must be requested from VIZULO and studied before the repair is attempted.
- LED modules, lens and LED drivers can be changed on an installed luminaire, but it is advised to perform this task indoor to avoid water entering the luminaire.
- Spare parts (lens, LED modules and drivers) should be ordered from the information available on the luminaire label.
Dimensions
Install the diffuser only in a clean room using gloves!
Diffuser cover may accumulate small electrostatic charges that make it susceptible to dust and other small particles.
It should only be cleaned using dry microfiber cloth or compressed air duster. 
Remove all protective before installing the device! 
Mounting dimensions
Module mounting
WARNING!
- Do not touch LED modules!
- Do not put any tools or other items on LED modules!
- In case any LED is physically damaged (example shown below) the warranty is void.
Energy efficiency class of contained light source(s)
FAQ
- Q: What should be done before turning on the luminaire?
A: The luminaire should be mounted according to the mounting instructions or any applicable regulations. - Q: Who should perform actions with the luminaire?
A: Any actions with the luminaire must be performed by a qualified person certified according to national regulations.
Documents / Resources
 |
VIZULO Pine Connect LED Linear Luminaire [pdf] Instruction Manual Gen2, Pine Connect LED Linear Luminaire, Connect LED Linear Luminaire, LED Linear Luminaire, Linear Luminaire, Luminaire |