VIP-VISION-logo

VIP VISION INTKIT-A1 Analogue 4-Wire Video Intercom

VIp- VISIO-NINTKIT-A1-Analogue-4-Wire-Video-Intercom-

Introduction

Thank you for purchasing this Intercom System. This install guide covers basic setup and installation for your intercom system. For detailed technical support and software downloads, visit our Help Centre at: help.c5k.infoVIp- VISIO-NINTKIT-A1-Analogue-4-Wire-Video-Intercom-1IMPORTANT:

  • Door Stations are designed to mounted in a sheltered location, not exposed directly to weather.
  • When installing the Door Station, apply outdoor silicone sealant between the Door Station and the wall, and seal the hole that has been created for the cable to prevent water ingress. If using a mounting box, ensure the box is also sealed, and the included waterproof rubber seals are used when installing the screws.

Included ComponentsVIp- VISIO-NINTKIT-A1-Analogue-4-Wire-Video-Intercom-2

Mounting GuideVIp- VISIO-NINTKIT-A1-Analogue-4-Wire-Video-Intercom-3

Front PanelVIp- VISIO-NINTKIT-A1-Analogue-4-Wire-Video-Intercom-5

Indoor MonitorVIp- VISIO-NINTKIT-A1-Analogue-4-Wire-Video-Intercom-6

Back PanelVIp- VISIO-NINTKIT-A1-Analogue-4-Wire-Video-Intercom-7

Name Description
 

Power

PWR 12VDC positive input
G 12VDC negative input
 

Camera Ports

CAM Analogue camera signal input
G Analogue camera signal ground
 

 

 

Door Station Ports

P1, P3 12VDC positive output to door station
V1, V3 Video signal
A1, A3 Audio signal
G Common ground for door stations
 

 

 

Indoor Monitor Ports

P2, P4 12VDC positive input to monitors
V2, V4 Video signal
A2, A4 Audio signal
G Common ground for monitors
WiringVIp- VISIO-NINTKIT-A1-Analogue-4-Wire-Video-Intercom-8

Port connection rules

  • Port A of the indoor monitor can be connected to Port C of another indoor monitor.
  • Port B of the indoor monitor can be connected to Port D of another indoor monitor.
  • Port A of the indoor monitor cannot be connected to Port B or D of another indoor monitor.
  • Port C of the indoor monitor cannot be connected to Port B or D of another indoor monitor.

Wiring Example – One Door Station and One Indoor MonitorVIp- VISIO-NINTKIT-A1-Analogue-4-Wire-Video-Intercom-9

Wiring Example – Three Door Stations and One Indoor MonitorVIp- VISIO-NINTKIT-A1-Analogue-4-Wire-Video-Intercom-10

Two Door Stations and Three Indoor MonitorsVIp- VISIO-NINTKIT-A1-Analogue-4-Wire-Video-Intercom-11

Setup MenuVIp- VISIO-NINTKIT-A1-Analogue-4-Wire-Video-Intercom-12

For detailed technical support and software downloads, visit our Help Centre at: help.c5k.info

All products, designs and software may be subject to change without prior written notice. Information, layout and graphics presented in this guide are the property of their respective owners. See www.c5k.info for more information.

Documents / Resources

VIP VISION INTKIT-A1 Analogue 4-Wire Video Intercom [pdf] User Guide
INTKIT-A1 Analogue 4-Wire Video Intercom, INTKIT-A1, Analogue 4-Wire Video Intercom

References

Leave a comment

Your email address will not be published. Required fields are marked *