VIMAR 09592 NEVE UP 2 Way Switch Carbon Matt
Specifications
- Input Voltage: 100-240 V~, 50/60 Hz
- Power Consumption: 0.55 W
- Wireless Frequency: 2400-2483.5 MHz
- Maximum Load:
- 250 W @ 100 V~
- 500 W @ 240 V~
- 50 W @ 60 Hz
- 100 W @ 120 W
- 125 VA @ 250 VA
Product Usage Instructions
Step 1: Power Connection
- Connect the product to a power source with an input voltage of 100-240 V~ and a frequency of 50/60 Hz.
Step 2: Wireless Setup
- Ensure the wireless frequency is within the specified range (2400-2483.5 MHz) for optimal performance.
Step 3: Maximum Load
- Make sure not to exceed the maximum load specifications to prevent any damage to the product.
Product Information
Download the View Wireless App from the stores onto the tablet/smartphone you will be using for configuration
TWO OPERATING MODES (ALTERNATIVE)
Depending on the mode you select, you will need.- Gateway Art. 09597
View the App for management via smartphone/table- Alexa, Google Assistant, Siri, and Homekit voice assistants for possible voice operation
Smart Home Hub
Samsung SmartThings Hub Amazon Echo Plus, Eco Show or Echo Studio
FRONT AND REAR VIEW
- A: Button
- B: LED
- C: Output for connection to a reversing switch or an electro-mechanical switch
- D: Input for wired push button: remote control (for Bluetooth technology and Zigbee technology mode) or scenario recalling (only for Bluetooth technology mode)
CONNECTIONS
- Connecting an individual lighting device
- Example of a light circuit with push buttons and relays in a new system
- IMPORTANT The electronic switch must be powered with the same L and N that power the load.
- In the event of installation with wired multi-way/two-way switches, the electronic switch should be connected so that it is always powered and therefore should be installed instead of the wired two-way switch furthest from the load.
- Example of a two-way switch with traditional push buttons in a new system.
For lighting devices with relays
FEATURES
- Rated supply voltage 100-240 V~, 50/60 Hz
- Dissipated power 0,55 W
- RF transmission power < 100mW (20dBm)
- Frequency range 2400-2483.5 MHz
- Operating temperature (indoor use) -10 °C ÷ +40 °C
TERMINALS
- (L, N) for line and neutra
- The max distance between the IoT device and the push button is 50 m with a cable with a minimum cross-section of 1.5 mm2
- 2 terminals (1 and 2) for the switch output
CONTROLLABLE LOADS
- For correct load state signaling, connect a 2 W minimum load
INSTALLATION RULES
- The device must be completed with interchangeable buttons and installed in flush mounting boxes or surface mounting boxes with Neve Up mounting frames and cover plates.
- The electronic switch shall be protected by a directly associated fuse with a rated breaking capacity of 1500 A or a circuit breaker with a rated current not exceeding 10 A.
- Installation must be carried out with the system switched off. Install the buttons onto the switch mechanism before powering up the system.
- IMPORTANT: the electronic switch must be powered with the same L and N that power the load.
- In the event of installation with wired multi-way/two-way switches, the electronic switch should be connected so that it is always powered and therefore should be installed instead of the wired two-way switch furthest from the load.
- REACH (EU) Regulation no. 1907/2006 – Art.33. The product may contain traces of lead.
- The Apple, iPhone, and iPad logos are trademarks of Apple Inc., registered in the United States and other Countries and Regions. App Store is a service trademark of Apple Inc.
- Google is a trademark of Google LLC. Amazon, Alexa, and all related logos are trademarks of Amazon.com, Inc. or its affiliates.
- DEVICE DETAILS, CONFIGURATION, AND WEEE INFORMATION CAN BE DOWNLOADED IN PDF FORMAT FROM THE PRODUCT DATA SHEET ON www.vimar.com.
- Viale Vicenza, 14
- 36063 Marostica VI – Italy
- 49401873A0 02 2409 www.vimar.com
Frequently Asked Questions
- Q: What are the trademarks mentioned in the user manual?
- A: The trademarks mentioned include Apple, iPhone, iPad, Google, Amazon, Alexa, and related logos.
- Q: Where can I find more detailed information?
- A: You can download device details, configuration, and WEEE information in PDF format from the product data sheet on www.vimar.com
Documents / Resources
 |
VIMAR 09592 NEVE UP 2 Way Switch Carbon Matt [pdf] Owner's Manual 09592, 09592 NEVE UP 2 Way Switch Carbon Matt, NEVE UP 2 Way Switch Carbon Matt, 2 Way Switch Carbon Matt, Switch Carbon Matt, Carbon Matt, Matt |