VEVOR HS110 Mini Split Stand
Overview
The VEVOR HS110 mini split stand is a modular stand system designed to support a mini split outdoor unit. Read the full manual before operating, and keep children away—this product is not a toy.
Technical Specifications
| Product Name | Mini Split Stand |
|---|---|
| Model | HS110 |
| Product Size (mm) | 710~1200 * 550 * 360 |
| Max Load (kg) | 250 |
Quick Assembly Guide
- Insert four bases into the side poles. Assemble using 4 sets of M8 washers and M8 self-locking nuts.
- Install two horizontal poles using M8 washer, M8*16 bolt, M8 cup nut, and M8 spring washer.
- Install the remaining two horizontal poles using M8 washer, M8 spring washer, M8*16 bolt, M8 cup nut, and M8 spring washer.
- Install the buffer pads using 4 sets of M8 washers, M8*25 bolts, and M8 self-locking nuts.
VEVOR Support Center
This is the original instruction, please read all manual instructions carefully before operating. VEVOR reserves a clear interpretation of our user manual. The appearance of the product shall be subject to the product you received. Please forgive us that we won’t inform you again if there are any technology or software updates on our product.
IMPORTANT SAFEGUARDS
WARNING: Read and understand this entire manual before operating or servicing this product. Failure to follow these warnings and instructions can cause personal injury or damage to valuable property. Avoid children using the product. And this product is not a toy. Do not allow children to play.
PACKAGE LIST
| No. | Name | Picture | QTY |
|---|---|---|---|
| 1 | Side pole | 2 | |
| 2 | Horizontal pole | 4 | |
| 3 | Base | 4 | |
| 4 | Bolt M8*16 | 12 | |
| 5 | Washer φ18*1mm | 24 | |
| 6 | Spring washer M8 | 12 | |
| 7 | Self-locking nut M8 | 8 | |
| 8 | Cap nut: M8 | 4 | |
| 9 | Bolt M8*25 | 4 | |
| 10 | Buffer pad Φ40*10 | 4 | |
| 11 | Open end wrench 10-13 | 2 | |
| 12 | Expansion screw M8*70 | 4 | |
| 13 | Manual | 1 |
ASSEMBLY INSTRUCTIONS
Step 1
Insert four bases into the side poles, assemble them with 4 sets of M8 washers and M8 self-locking nuts.
Step 2
Install two horizontal poles with M8 washer, M8*16 bolt, M8 cup nut and M8 spring washer.
Step 3
Install another two horizontal poles with M8 washer, M8 spring washer, M8*16 bolt, M8 cup nut and M8 spring washer.
Step 4
Install the buffer pads, using 4 sets of M8 washers, M8*25 bolts and M8 self-locking nuts.
Troubleshooting
Note: The provided manual text includes assembly steps and safeguards but does not include troubleshooting guidance. If you have a specific issue (e.g., parts not fitting or instability), check that you used the correct hardware quantities and fastener types as listed, and confirm each step was completed in order.
Documents / Resources
 | HS110 Mini Split Stand |
References
- vevor.com/pages/contact-us/KDDMZJDCZJ90J4KT3V0www.vevor.com
- User Manualmanual.tools