VEVOR DC109 Button Maker Machine Instruction Manual

VEVOR DC109 Button Maker Machine

Specifications

Accessories

• Metal Cover: x100
• Plastic Back: x100
• Rubber Magnet: x100
• Transparent Film: x100
• White Paper: x100
• Wrench: x2
• Cutting template: x1

Paper/Material Note

• Paper thickness: 115g–160g
• Paper size: same as the transparent film / cutting template

Quick Use Guide

1. Cut pictures according to the cutting template.
2. Put the metal cover into mould A.
3. Place the picture and transparent film into mould A.
4. Rotate mould A for the first press (ensure there is a gap at the upper mould).
5. Put the plastic back into mould B.
6. Ensure the plastic back sits well flat.
7. Rotate mould B for the second press (ensure there is no gap at the upper mould).
8. Stick the rubber magnet at the back.
9. Finished.

NOTE: Please be sure to read the manual before operating! The finished products made before you are familiar with the operation may not be successful. Please practice more to get familiar with the feeling! This is the original instruction; please read all manual instructionscarefullybefore operating. VEVOR reserves a clear interpretation of our usermanual. The appearance of the product shall be subject totheproductyoureceived. Please forgive us that we won’t informyou againif thereareanytechnology or software updates on our product.

SAFE INSTRUCTIONS

1. This badge machine is only for the intended purpose. Don’t apply in other applications that exceed safety considerations.
2. Children cannot operate this product unless accompanied by an adult.
3. Pay attention to safety during operation, and avoid crushing fingers.

PRODUCT INTRODUCTION

STRUCTURE DIAGRAM

ACCESSORIES

NOTE: The paper thickness needs to be in the range of 115g-160gandthepaper size should be the same as the transparent film/cuttingtemplate!

OPERATION

1. Cut pictures according to the Cutting template.
2. Put the metal cover into mould A.
3.  Put the picture and transparent film into the mould A in order.
4. 
5. Rotate the mould A; first press; ensure there is a gap at the upper mould.
6. Put the plastic back into mould B.
7. Mind that make sure the plastic back sits well flat.
8. Rotate mould B, second press; mind that there should be no gap at the upper mould.
9. Stick the rubber magnet on the back.
10. Well done.

Troubleshooting

• If your first finished products are not successful, the manual advises that you may need more practice to get familiar with the operation.
• During pressing, ensure the correct gap condition: mould A should be pressed with a gap at the upper mould, while mould B should be pressed with no gap at the upper mould.
• Confirm material compatibility: use paper thickness 115g–160g and the same paper size as the transparent film/cutting template.
• Ensure the plastic back sits well flat in mould B before the second press.