VEVOR BDMC-2 Button Maker Machine
Quick Setup
- Make sure the blank side is facing up relative to the black mark.
- Rotate the top half 180 degrees to the right.
- Place the top cover on with the concave side facing up.
- Place the circular design paper inside.
- Put in the back cover with the pin side facing up.
- Spin the top half back to its original position.
- Lift the lid open.
- Push down firmly, then rotate the top half 180 degrees to the right again to complete your badge.
PRODUCT INFO
NOTE: Please be sure to read the manual before operating!
The finished products made before you are familiar with the operation may not be successful. Please practice more to get familiar with the feeling!
This is the original instruction, please read all manual instructions carefully before operating. VEVOR reserves a clear interpretation of our user manual. The appearance of the product shall be subject to the product you received. Please forgive us that we won’t inform you again if there are any technology or software updates on our product.
SAFETY INSTRUCTIONS
- This badge machine is only applied for the intended purpose. Don’t apply in other applications which exceed safety considerations.
- Children cannot operate this product unless accompanied by an adult.
- Pay attention to safety during operation, and avoid crushing fingers.
SAVE THIS MANUAL
PRODUCT INTRODUCTION
| Specification | Details |
|---|---|
| Model | BDMC-2 |
| Specifications of Finished Badges | Φ58mm |
| Color | Yellow |
STRUCTURE DIAGRAM
ACCESSORIES INTRODUCTION
OPERATION
- Rotating the top half 180 degrees to the right.
- Put on the top cover with its concave side facing up.
- Place the circular design paper in.
- Put the back cover in, with the pin side facing up.
- Spin the top half back to its original position.
- Lift the lid open.
- Push down firmly.
- Spin the top half 180 degrees to the right, and your badge is done!
Troubleshooting
- Badges do not come out successfully: The manual advises that products made before you are familiar with the operation may not be successful—practice more to get familiar with the feel.
- Operation feels incorrect: Ensure the loading steps are followed, including having the blank side facing up the black mark and placing the top cover (concave side up) and back cover (pin side up) correctly.
- Paper-related issues: Verify the paper thickness is in the range of 90g–120g and the paper size is 54mm.
Documents / Resources
 | BDMC-2 Button Maker Machine |
References
- User Manualmanual.tools
Published: September 28, 2026