VEVOR 4500 End Socket Instruction Manual

VEVOR 4500 End Socket

INTRODUCTION

This is the original instruction, please read all manual instructions carefully before operating. VEVOR reserves a clear interpretation of our user manual. The appearance of the product shall be subject to the product you received. Please forgive us that we won’t inform you again if there are any technology or software updates on our product.

Warning-To reduce the risk of injury, user must read instructions manual carefully.

WARNING:
The product complies with relevant standards and regulations. Installation of this device must comply with all applicable regulations, and it should only be operated in well-ventilated areas. Please read the user manual before installing and using this equipment.

• DO NOT EXCEED MAXIMUM LOAD CAPACITY – Risk of collapse.
• PROFESSIONAL INSTALLATION RECOMMENDED – Ensure secure mounting.
• USE APPROPRIATE FASTENERS FOR CABINET MATERIAL KEEP HANDS CLEAR DURING DRAWER MOVEMENT
• DO NOT USE IN WET OR CORROSIVE ENVIRONMENTS PERIODICALLY CHECK FOR LOOSENESS OR WEAR
• DO NOT MODIFY OR ALTER SLIDE MECHANISM

1. Please assemble the product in strict accordance with the instructions. Incorrect assembly could be hazardous.
2. Please wear safety goggles and work gloves properly during assembly.
3. Do not try to assemble the product when feeling tired or when under the influence of alcohol, drugs, or medication.
4. Load-bearing capacity and other product parameters are applied to the properly and completely assembled product only.
5. Separate and count all parts and hardware.
6. Prepare the following tool: Philips Head Screwdriver.
7. If using power tools, please be careful to slow down and stop when needed.
8. Two people are required for assembly.
9. Follow the intended uses only. Save the instructions.

Part List (pcs)

Dimensions

INSTALLATION INSTRUCTION

STEP1 :Cabinet Installation For Ball Bearing

1. Install The Tail Bracket Inside The Cabinet According To The Screw Diagram.
2. The bead frame should be pushed flat with the file glue to facilitate the installation of the drawer.

STEP2: Drawer Slide Installation
Screw the ball rail to the outside of the drawer as shown in the layout diagram.

STEP3 :Drawer Installation
On both sides of the inner rail to the upper middle rail file glue through the slot to install the drawer on.

STEP4: Disassemble Drawer
When removing the drawer, pull the drawer out by using the fork in the enlarged image to pull it out completely.