ZZZ 241CM
Wire Extension Kit for Curb Mounted Skylight VCS
Remove solar panel:
- Remove screws (retain for re-installation).
- Lift off.
- Unplug.
Temporarily remove skylight:
- Remove screws.
- Lift off the skylight and rotate upside down on a scratch-free surface.
Install wire:
- Connect wires.
- Route wire into the “J” channel along the bottom and side of the skylight as shown.
Replace skylight:
- Secure screw.
- Apply downward pressure to the top of the skylight frame while securing the screws.
Mount original screws at top of skylight:
- Place solar panel as shown and mark holes.
- Drill holes Ø 9/64″ (3.5 mm) and only ¼” (6 mm) deep. Do not penetrate the flashing!
- Insert original screws leaving room for installation of solar panel.
Plug, install, and secure solar panel:
- Connect plug connectors.
- Install solar panel over screws and tighten screws.
AU: VELUX Australia Pty. Ltd.
1300 859 856
www.velux.com.au
CA: VELUX Canada Inc.
1 800 88-VELUX (888-3589)
www.velux.ca
NZ: VELUX New Zealand Ltd.
0800 650 445
www.velux.co.nz
US: VELUX America LLC
1-800-88-VELUX
www.veluxusa.com
INSTALLATION INSTRUCTIONS FOR ZZZ 241CM. ©2017, 2021 VELUX GROUP ®VELUX, VELUX INTEGRA, AND THE VELUX LOGO ARE REGISTERED TRADEMARKS USED UNDER LICENSE BY THE VELUX GROUP
Documents / Resources
 |
VELUX VCS 2234 Wire Extension Kit for Curb Mounted Skylight VCS [pdf] Instruction Manual VCS 2234, Wire Extension Kit for Curb Mounted Skylight VCS |
