Vanemar D1-E Entry Sensor User’s Guide User Manual

Vanemar D1-E Entry Sensor

Technical Specifications

Model | D1-E 

• Working Voltage | DC3V(1xCR2032)
• Detection Distance | <15 mm <0.6 in
• Wireless Network Distance | ≤100m(open area) ≤328 feet
• Working Temperature | -10°C ~ 55°C <br> 14°F ~ 131°F
• Working Humidity | ≤95%RH
• Sensor Dimensions | 25.1×38.3×12.5 mm <br> 0.99×1.51×0.49 in
• Magnet Dimensions | 11.4×31.85×12.5 mm <br> 0.45×1.25×0.49 in
• FCC ID | 2AK7XD1-E

Please read the guide carefully before installing and using the device. The guide may be updated; access the latest version at support.vanemar.com

Meet Vanemar Entry Sensor
Designed to enhance awareness on your boat, the Vanemar Entry Sensor signals potential openings in doors, windows, or drawers.

• Signals when an opening is detected.
• May warn of potential tampering with the sensor’s cover.
• May warn of potential tampering with the sensor’s cover.

In the box

INSTALLATION

Safety And Preparation

Securing the Boat
Before beginning the installation, make sure the boat is stationary and securely moored to provide a stable environment,

Work Environment
Ensure the area is well-ventilated and free of clutter to facilitate a safe installation process.

I-Pairing
Ensure the battery insulation pull tab is removed before pairing. Open the Vanemar App. Tap ‘+’ or ‘Add device’ button in the ‘Devices’ menu and follow the on-screen instructions.

Fixing in Place

• Pick a flat indoor spot for installation, such as on the inner side of a door, window, or drawer. Attach the magnet to the moving part, like the door or window itself. Before mounting, ensure that the surface is clean.
• Please note that the distance between the sensor and Che rnagnet should not exceed 15 rnrn (approxirndtely 0.6 inches). The magnet can be placed on either side of the sensor, offering a flexible installation.
• Peel the double-sided tape on both the cover and the magnet. Secure them by pressing firmly to the spot.

WARNING: The device’s disassembly hole is located on the bottom side. When mounting the device, make sure to leave enough space underneath to allow for its removal,

Indicators

LED State | Status 

• Red flash once | Opened / Closed
• Rapidly flashing green | Searching for Gateway (Pairing Mode)
• Slowly flashing green | Unpaired
• Solid green for 3 seconds, then off | Paired Successfully

Using the Networking Button

• To put your device into pairing mode, press and hold the networking button with the included reset tool until the green LED starts flashing rapidly. This indicates that the device is ready to pair. Once successfully paired, the LED will remain solid green for 3 seconds before turning oft
• To unpair your device, press and hold the networking button with the reset tool until the green LED flashes slowly, which should take about 5 seconds. This indicates that the device has been successfully disconnected.

Changing the Battery

Check the Vanemar App for low battery alerts. The device requires a single CR2032 battery. Insert the battery with the positive (+) side facing outward, following the polarity markings in the battery compartment. Do not use damaged or leaking batteries.

WARNING: Keep new and used batteries OUT OF REACH OF CHILDREN. This product contains a button cell or coin battery. DEATH or serious injury can occur if ingested.