UNIVERSAL
LOW CURRENT SOURCE UNIT HARNESS
PART #: UTVS-HRN-LC-SRC
UTVS-HRN-LC-SRC Low Current Harness Plus Rocker Switch
Step 1: Mount switch to your desired location.
Step 2: Route harness to your Polaris Pulse Bar or factory bus bar.
Install on RZR: Route Pulse plug from the switch and connect to the Pulse bar.
Universal Install: Route bus bar wires using the universal adapter from the switch to the factory bus bar.
Step 3: Connect power and ground of the source unit harness to the source unit.
*Use this configuration if you want the head unit to work on Constant power controlled by rocker switch.
Your head unit will work anytime regardiess of key on.
Red Ring Terminal goes to constant post – Constant Power (fused by 10 amp)
Yellow Ring Terminal goes to ACC post – Acc Power used to light up lower LED on switch
Black Ring Terminal goes to Ground Post
*Use this configuration if you want the head unit to work on ACC power controlled by rocker switch. The head unit will only work when key is on.
Red Ring Terminal goes to ACC Post- Accessory Power (fused by 10 amp)
Yellow Ring Terminal goes to ACC Post- Acc Power used to light up lower LED on switch
Black Ring Terminal goes to Ground Post
Note: If you have our UTV Stereo 2nd battery kit installed in your vehicle, make sure your power source is properly connected to the accessory battery.
https://youtu.be/aSxGu-9X5qw
NEED HELP?
EMAIL TECH SUPPORT AT:
INFORUTVSTEREO.COM OR
CALL: 480.616.2299
Documents / Resources
 |
UTV Stereo UTVS-HRN-LC-SRC Low Current Harness Plus Rocker Switch [pdf] Instructions UTVS-HRN-LC-SRC, UTVS-HRN-LC-SRC Low Current Harness Plus Rocker Switch, UTVS-HRN-LC-SRC, Low Current Harness Plus Rocker Switch, Current Harness Plus Rocker Switch, Harness Plus Rocker Switch, Plus Rocker Switch, Rocker Switch |