
UTONG CPP-7950 Mini Wireless Speaker

SPECIFICATIONS
- Model # : CPP-7950
- Bluetooth® QDID: 172491
- Bluetooth® DID: D066434
- FCC ID: 2AJ9K-UT2600
- Output Power: 3W
- Battery: 300mAh
- Music Play time: Up to 1.5 hours
- Speaker Output Frequency range: 150Hz – 20Khz
Dear customer:
- Thank you for purchasing Mini Wireless Speaker. Please read this user guide carefully before operation and save these instructions for future reference.
Packaging included:
- Mini Speaker………………………………………………………..1 pc
- Charging Cable ……………………… …………………………..1 pc
- User manual ………………………………………………………..1 pc
FEATURES

FUNCTION KEYS

ON/OFF
- Turn ON: Press and hold ON/OFF button, you will hear a prompt tone, and the LED light will start flashing.
- Turn OFF: Press and hold ON/OFF button till to hear a prompt tone.
BLUETOOTH® PAIRING
- Swith ON/OFF button to “ON”, you will hear a reminder tone, and LED light will start flashing, speaker now is in pairing mode.
- Place the speaker and Bluetooth® device (phone or music device) so that they are no further than 1 meter apart.
- Activate the Bluetooth® function on your Bluetooth® device (phone or music device).
- Please refer to the manufacturer’s instruction manual to enable Bluetooth® on your device.
- Select the speaker “CPP-7950” from the list of available Bluetooth® devices.
- Once paired sucessfully, you will hear the confirmation tone. If pairing is unsuccessful, turn off the speaker first and then re-pair following the above steps.Once you have paired the speaker with a device, the speaker will remember this device and will pair automatically when the device’s Bluetooth® is activated and in range.
- The speaker will attempt to automatically connect tothe last device it was paired with when switched on. If you want to pair it with a new device, please follow the steps outlined above.
PLAY MUSIC
- Short press the ON/OFF button to pause music. Short press it again to resume music play.
- Select the previous or next track and adjust the volume on your device.
Hands-free Phone Call Operation
- Short the ON/OFF button to answer an incoming call; long-press to reject it.
- Double-press the ON/FF button to redial the last contacted number
CHARGING
- The speaker includes a built-in rechargeable battery.
- It is recommended to charge the battery fully prior to first use.
- Connect the USB cable to a computer or other USB charging port and the Type-C charging port into charging port of the speaker.
- A red light turns ON during charging and turns OFF after full charged.
IMPORTANT NOTES
- This product is not a toy.
- Do not drop or damage the speaker.
- Do not use in humid or extreme temperatures.
- Do not place the speaker near an open flame.
- Do not block the sound of the speaker while it is in use.
- Do not use the unit if it has been dropped or damaged in any way.
- If damaged, do not attempt to repair or disassemble the speaker.
The Bluetooth® word mark and logos are registered trademarks owned by Bluetooth SIG, Inc.
- Bluetooth® DID: D066434
- Bluetooth® QDID: 172491
- Model#: CPP-7950
FCC statment
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
- This device may not cause harmful interference, and
- this device must accept any interference received, including interference that may cause undesired operation.
FCC ID: 2AJ9K-UT2600
- Do not expose the battery to heat sources, extended direct sunlight or other high-temperature environments.
- Avoid drops and excessive impacts to the battery.
- Do not disassemble, attempt to repair or replace any part of the housing or battery.
- Do not attempt to charge the battery using any other method, apparatus, or connections other than the device’s charging cable.
- Never dispose of batteries in the garbage. This is unlawful under state and federal environmental laws and regulations. Always take used batteries to your local battery-recycling center.
- FCC Compliance: warning: Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
Federal Communications Commission (FCC) Statement.This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
- This device may not cause harmful interference, and
- this device must accept any interference received, including interference that may cause undesired operation.
Note:
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide Reasonable protection against harmful interference in a residential installation. This equipment generates,uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of·1the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Warning:
Changes or modifications made to this device not expressly approved by the manufacturer may void the FCC authorization to operate this device.Note: The manufacturer is not responsible for any radio or TV interference caused by unauthorized modifications to this equipment. Such modifications could void the user’s authority to operate the equipment.
RF exposure statement:
- This device complies with FCC RF radiation exposure limits set forth for an uncontrolled environment.The device is installed and operated without restriction.
Documents / Resources
![]() | CPP-7950 Mini Wireless Speaker |
References
- User Manualmanual.tools
