Unity U-BB1 Countertop Merchandising Bar Cooler User Manual

Q: How do I adjust the temperature?
- A: Use the temperature control dial on the control panel to adjust the temperature settings.
Q: Can I place the cooler directly under sunlight?
- A: It is not recommended to place the cooler under direct sunlight as it may affect its cooling efficiency.
Q: What should I do if the cooler is not cooling properly?
- A: Check if the power supply is adequate and the temperature settings are correct. If issues persist, contact customer support.

SAFETY PRECAUTIONS

To ensure proper use, please thoroughly study these SAFETY PRECAUTIONS before operating the Unit.

The purpose of the safety precautions in this manual is to ensure safe and correct use of the unit to minimize risks that could cause serious damage and injury to you or other persons. The safety precautions are divided into WARNINGS and CAUTIONS.
Cases where improper handling of the unit could lead to death or serious injury are listed under the “AWARNING” heading. However, the cases listed under the “CAUTION” heading could also lead to serious results. To ensure the safety, adhere strictly to both types of safety precautions. capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning the use of the appliance by a person responsible for their safety.

Children should be supervised to ensure that they do not play with the appliance.
Warning: Do not use mechanical devices or other means to accelerate the defrosting process, other than those recommended by the manufacturer.

This appliance can be used by children aged 8 years and above and persons with reduced physical, sensory, or mental capabilities or lack of experience and knowledge if they have been given supervision or instruction concerning the use of the appliance in a safe way and understand the hazards involved. Children shall not play with the appliance. Cleaning and user maintenance shall not be done by children without supervision.
If the supply cord is damaged, it must be replaced by the manufacturer, its service agent, or similarly qualified persons in order to avoid a hazard.
When disposing of the appliance, do so only at an authorized waste disposal center. Do not expose to flame.

Warning: The lamp must not be replaced by the user! If the lamp is damaged, contact the customer helpline for assistance.
The A-weighted emission sound pressure level is below 70 dB(A)

The appliance shall be disconnected from its power source during cleaning or maintenance and when replacing parts.
Warning: Do not use electrical appliances inside the food storage compartments of the appliance, unless they are of the type recommended by the manufacturer.

Warning: To avoid a hazard due to the instability of the appliance, it must be fixed in accordance with the instructions.
The symbol is a warning and indicates the refrigerant and insulation-blowing gas are flammable.

Warning: Risk of fire / flammable materials.
Warning – Do not store explosive substances such as aerosol cans with a flammable propellant in this appliance.

Warning – The refrigerant and insulation blowing gas are flammable. When disposing of the appliance, do so only at an authorized waste disposal center. Do not expose to flame.
WARNING Improper handling of the unit could lead to death or serious injury.

CAUTION Improper handling of the unit could lead to serious results depending on the circumstances.

PRECAUTIONS FOR INSTALLATION

WARNING: Installation should be performed only by the dealer or a qualified expert. Attempting to install the unit yourself could result in water leakage, refrigerant leakage, electrical shock, or fire.

WARNING

All repairs, disassembly, and modifications should be performed only by qualified technicians. Attempting to perform these yourself could result in a fire, malfunction, and injury.
Never put flammable or volatile substances into the unit as an explosion and fire could result.
Use a dedicated wall outlet. Do not use extension cords or convenience receptacles as this could result in electrical shock, overheating, and a fire.
The cooler is intended for storage and display of beverages for sale. Do not use for other purpose than intended as this could adversely affect items placed in the unit.
For indoor use only. Using the unit in a location exposed to rain could result in electrical leakage and electrical shock.
Install the unit in a location where the floor is sturdy enough to support the load of the unit. If the floor is not sturdy enough or installation is incorrectly performed, the unit could tip over and falling shelves and products could cause personal injury.
Never splash water directly onto the product or wash with water as short-circuit and electrical leakage could result.
Do not damage, modify, excessively bend, strain, twist, or bundle up the power cord. Also, placing heavy objects on the power cord or squeezing it in a tight place could damage it, possibly resulting in electrical shock or fire.
Never use flammable spray cans or leave flammable substances near the unit. Sparks from electrical switches could result in explosion and fire.
Never attempt to insert fingers, sticks, etc. Into the cold air suction outlet as a circulation, the fan is rotating at high speed inside the outlet. Injury, electrical shock, and improper operation could result.
Never place heavy objects or items containing water on top of the unit. Objects could fall and cause injury and spilled water could deteriorate the insulation of electrical components and result in electrical leakage.
If you find gas leakage, please don’t touch the appliance. Turn it off and open the doors and windows for ventilation. Gas leakage could cause explosion, fire, and fire injury.
Store the unit in a location where it is not exposed to rain. Using a unit that has been exposed to rain could result in electrical leakage and electrical shock.
Leave disassembly and disposal of the unit to qualified experts.

WELL VENTILATED PLACE

Please make sure there is more than 10 cm space between UPRIGHT COOLER and the wall. If there is no space, the cooling capacity can drop down.

Never hang from the door or climb onto the unit. The unit could tip over or fall and cause material damage or injury.
Grasp the handle when closing the door. Holding at other positions could result in pinched fingers and injury.
When disconnecting the power cord plug from the wall outlet, hold the plug main body close to the outlet. Pulling the cord could cause wire breakage, possibly resulting in overheating and fire.

Keep away from hot air sources Cooling performance is reduced if the unit is placed near heat sources such as hot plates and stoves and if it is exposed to direct sunlight.
Should the unit need temporary storage, make sure not to store the unit in a location where children play and take precautions so that the door cannot be completely closed. This will minimize the risk that a child becomes trapped inside the compartment.
If installation in a damp location is unavoidable, also install an electrical leakage circuit breaker. If no electrical leakage circuit breaker is installed, electrical shock could result.

Disconnect the power cord plug from the wall outlet before moving the unit and make sure that the power cord is not damaged during transport. A damaged power cord could result in electrical shock and/or fire.
Do not push your hand against or apply excessive force to glass surfaces as the glass could break and cause injury.
Make sure that the unit does not tip over or fall when it is moved. A falling unit could cause serious injury.

Do not throw items onto the shelves and do not place items totaling more than 25 kg on each shelf. The shelf could fall down, possibly causing injury.
Be sure to attach and secure shelves correctly. An improperly attached shelf could fall and cause injury.

HOW TO USE

BEFORE USE

Remove shipping packages, tape, etc, and leave doors open. Ventilate for a while.
The unit is cleaned before shipment. However, clean the compartment interior after delivery.
Please insert the power supply plug into the wall outlet, single-phase to correct the voltage.

Allow the unit to operate for about 1 hour to cool the compartment before placing items in the cooler.

WAIT 5 MINUTES OR MORE BEFORE RE-STARTING

Restarting the unit immediately after it has been turned off may cause fuses to blow and activate the circuit breaker, the compressor may be overloaded, and/or other damage may occur.

TEMPERATURE ADJUSTMENT

The electronic controller has been factory set to cool the beverages to the lowest temperature approximately 1-5 Centigrade. Should you wish to alter the temperature set point, please adopt the following procedure.

Setting the set point (desired temperature)

Press SET for 1s, the set value will start flashing after a few moments;
Use or increase or decrease the value using UP or DOWN;

Press SET to contirm the new value.

Switching the device ON/OFF

Press more for more than 3s. The control and defrost algorithms are now disabled and the instrument displays the message OFF alternating with the temperature read by set probe.

Manual defrost

Press for DOWN more than 3s. (the defrost starts only when the temperature conditions are valid).

Access and setting

Press SET for 3s (the display will show “PS”);
To access the parameter menu, press SET;
Scroll inside the parameter menu using

To display/set the values of the parameter displayed, press SET, then /and finally SET to confirm the changes (returning to the parameter menu). To save all the new values and exit the parameter menu, press SET for 3s; To exit the menu without saving the changed values (exit by timeout) do not press any button for at least 60s.

DRAIN TRAY

Defrosting is performed automatically and drain water is collected in the drain tray.

Water in the drain tray is evaporated automatically. In humid environments, there will be a large amount of water in the drain tray, so please throw away drain water once a day.

EFFICIENT USE

To prevent cold air from escaping, open and close the door quickly and keep the door open for as short a time as possible.

Please install the unit in a well-ventilated place.

SHELF HEIGHT ADJUSTMENT

The shelf height can be adjusted.

Arrange the shelves under the dimensions of the items to be placed in the cooler.

PLACING ITEMS IN THE SHOWCASE

This showcase employs a forced circulation of the cold air system. If the circulation of cold air is obstructed, the items will not be adequately refrigerated. Pay attention to the following points:

Do not let items obstruct the cold air inlet and suction outlet.
Place items so that they do not protrude from the shelves. The gap between the shelves and the
Place sens frenzy on tin shelved air.

Commercial refrigeration display cooler.
This equipment is intended for the storage and display of non-potentially hazardous bottled or canned products only.

CLIMATE CLASS

32°C±2°C on appliances of climatic class 0, 1,2,3,4,6 or 8
43°C±2°C on appliances of climatic class 5 or 7

CLEANING

WARNING To prevent any electrical shock hazards or injury by rotating the circulation fan, always disconnect the power cord plug from the wall outlet before cleaning.

EXTERIOR AND COOLER COMPARTMENT
- Wipe with a soft, dry cloth. If very soiled, wipe with a cloth that has been moistened with a detergent
- Then wipe with a cloth that has been dipped in water.
- WARNING: Do not splash water directly onto the cooler and do not wash with water. Short-circuit and electrical shock could result.
- Clean the cooler regularly to keep it clean at all times.
- Never use polishing powder, soap powder, benzine, oil, or hot water as these will damage the painting and plastic components.

CHECKS
- To ensure the safety, perform the following checks after cleaning.
- Is the power cord plug firmly inserted into a dedicated wall outlet? Confirm that the plug is not abnormally hot.
- Check the power cord for cracks and damage. Should the slightest irregularity be observed, contact the dealer from whom you purchased this unit or our customer’s service.

IN THE CASE OF THE FOLLOWING

POWER FAILURE
- Keep opening and closing the door to a minimum.
- Avoid placing new items in the cooler as this will raise the temperature inside the compartment.
WHEN NOT USED FOR A LONG PERIOD
- Remove all items from the compartment and disconnect the power cord plug from the wall outlet.
- Clean the compartment interior and wipe away all water.
- To prevent mold formation and bad smell, leave the door open to dry the compartment completely.
TRANSPORTATION
- Disconnect the power cord plug from the wall outlet.
- When moving the cooler, make sure that the feet do not damage the power cord.
- Do not let the feet hit against floor steps, thresholds, etc.

TEMPORARY STORAGE
- Affix a piece of wood, etc. Between the door and main unit to prevent complete closing of the door. Make sure not to store the unused cooler at a location where children play. Should a child enter the compartment and the door is closed, the child may not be able to open the door from the inside.

BEFORE REQUESTING SERVICE

Please check the following items if you encounter problems with the unit. If the problem continues after taking the proper remedial actions, disconnect the power cord plug from the wall outlet. you per these are unit in the ear to our intent as The REQUIRED INFORMATION home below.

CAUTION To prevent any electrical shock hazards, do not disconnect the power cord plug from the wall outlet with wet hands.

Showcase sometimes stops running when the thermostat turns off.

INSTRUCTION MANUAL REQUIRED INFORMATION

Nature of malfunction (as accurately as possible)
Product number

Serial number
Customer’s name, address, phone number
Year and date of purchase

USRESTAURANT® RESERVES THE RIGHT TO CHANGE SPECIFICATIONS WITHOUT NOTICE

CONTACT INFORMATION

USR Brands, Inc.
Phone: 800-764-1172

www.usrestaurant.com.
sales@usrestaurant.com.

Documents / Resources

Unity U-BB1 Countertop Merchandising Bar Cooler [pdf] User Manual
U-BB1 Countertop Merchandising Bar Cooler, U-BB1, Countertop Merchandising Bar Cooler, Merchandising Bar Cooler, Bar Cooler, Cooler

References

User Manual

Unity U-BB1 Countertop Merchandising Bar Cooler

Specifications

FAQs