UCP-LOGO

UCP Flash Utility SOP

UCP Flash Utility SOP-FIG1

  1. UCP Flash Utility SOP-FEATURE

    UCP Flash Utility SOP-FIG2

  2. Execute the *.exe file
  3. If you see the UAC prompt message, press Yes

    UCP Flash Utility SOP-FIG3

  4. Wait for completion and press “Y” to restart the system

    UCP Flash Utility SOP-FIG4

  5. System will auto power on into BIOS and flash.
  6. Start flash update automatically and wait it completed.

    UCP Flash Utility SOP-FIG5 UCP Flash Utility SOP-FIG6

  7. After flash finish, system will reboot automatically.
  8. Boot system. Please press “Delete” key to enter BIOS Setup Menu.
  9. Press F1 key to switch Advanced Settings
  10. Choose Exit ” page and s elect “Load Default Setting” and press “Enter” key
  11. Select “ OK ” to load default settings

    UCP Flash Utility SOP-FIG7

  12. Choose Exit ” page and s elect “Save & Exit Setup” and press “Enter” key
  13. Select “ OK ” to restart

    UCP Flash Utility SOP-FIG8

Documents / Resources

UCP Flash Utility SOP [pdf] Installation Guide
Flash Utility SOP, Flash Utility, SOP Software, Software

References

Leave a comment

Your email address will not be published. Required fields are marked *