Smart controller
Product instructions
http://app.appurl.me/79816705697
Product description
USB smart controller supports infrared remote control equipment and RF radio frequency remote control Equipment, combined with other equipment to realize intelligent application scenarios.
Product specification
Name: USB Smart controller
Power input: DC 5V/1A
Communication method: WiFi,WiFi+RF433
Wireless type: 802.11 b/g/n 2.4G
RF frequency: 433.92MHz(RF version)
Working temperature: -10 —+45°C
Working humidity: 10%-90(YoRH (non-condensing)
Material: PC
Colour: Black
Size: 83*31*10mm
Networking settings
- Open the Smart Life APP ‘Home’, and click the add button `+’ in the upper right corner of the page.
- Select “Universal Remote Control” in the left column “Others”.
- Long press the reset button for more than 5 seconds until the device networking indicator flashes, and follow the APP prompts to add the device.
- After successfully adding, you can find the device in the “Home” list.
Add device
- Open the “Homepage” of the SmartLife APP, click on the smart controller, Select the type of equipment to be added (IR or RF);
- Select the equipment category to be added;
- According to the prompts on the page, first reset the added device into pairing Mode, and then click “Match Now”;
- Observe whether the equipment responds and makes a choice based on the actual situation;
- After successfully adding, you can find the device in the “Home” list;
- Click the device icon on the home page to enter the device control interface.
- Tip: If you need to control the device with other people, you can go to APP>My>Family Management>Enter Family>Add Members.
FCC Statement
Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
— Reorient or relocate the receiving antenna.
— Increase the separation between the equipment and receiver.
— Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
— Consult the dealer or an experienced radio/TV technician for help This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions (1)this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
RF warning for Portable device
The device has been evaluated to meet general RF exposure requirements. The device can be used in portable exposure conditions without restriction.
Documents / Resources
 |
tuya URF02 Smart Controller [pdf] Instructions URF02, 2A3LU-URF02, 2A3LUURF02, URF02 Smart Controller, Smart Controller, Controller |
