Trust-logo

Trust ZCTS-808 Zigbee Wireless Contact Sensor

Trust-ZCTS-808-Zigbee-Wireless-Contact-Sensor-PRODUCT

COMPATIBILITY

The contact sensor works with the Z1 ZigBee Bridge and the ICS-2000/Smart Bridge.

REPLACE THE BATTERY

Trust-ZCTS-808-Zigbee-Wireless-Contact-Sensor-FIG-1

Trust-ZCTS-808-Zigbee-Wireless-Contact-Sensor-FIG-2

  • Remove the backplate from the contact sensor.
  • Open de battery cover using a flat screwdriver.
  • Place the included CR2032 battery in the contact sensor. Note the positive and negative polarity in the compartment. Close the battery cover.

INDICATORS

Trust-ZCTS-808-Zigbee-Wireless-Contact-Sensor-FIG-3

The contact sensor contains a LED indicator (This is not a button) to show the status of the contact sensor. Please see below the meaning of the different LED indications.

LED FUNCTION TABLE

Connection modeLED will flash once per second for approximately 1 min.
Connected successfullyLED will stop flashing
Sensor resetLED will flash fast
Sensor triggered (When the sensor is opened for more then 10 mm)LED will flash once

DOWNLOAD APP

Trust-ZCTS-808-Zigbee-Wireless-Contact-Sensor-FIG-4

  • www.trust.com/zigbee
  • To connect the contact sensor with a Z1 ZigBee bridge or ICS-2000/Smart Bridge, first, get the App by scanning the QR code or go to trust.com/zigbee and install it.

CONNECT SENSOR

Trust-ZCTS-808-Zigbee-Wireless-Contact-Sensor-FIG-5

 

  • In the App, select a room, press the + button, and follow instructions. For manual set up of pushnotifications go to the rules tab, press the + button and select notification wizard.

MOUNT THE CONTACT SENSOR

Trust-ZCTS-808-Zigbee-Wireless-Contact-Sensor-FIG-6

Note: When mounting the contact sensor make sure both parts are mounted with as little space between as possible (max. 5mm). Remove the backplate by sliding it off the contact sensor and attach it with the included screws to a flat surface. Attach the small part of the contact sensor using the double-sided tape on the back and place the contact sensor on the backplate.

RESET THE CONTACT SENSOR AND ACTIVATE CONNECT MODE

Trust-ZCTS-808-Zigbee-Wireless-Contact-Sensor-FIG-7

Warning: This step will remove the sensor from the Z1 ZigBee Bridge or the ICS-2000/Smart Bridge. To reset the sensor press the button in the hole at the side of the sensor for approximately 5 sec with the included pin. The LED will flash fast to confirm the reset.

Activate connect mode: After resetting the sensor you can activate the connect mode by pressing the reset button for approx. 1 sec.

The wireless range increases when you add more ZigBee products (meshing). To learn more about meshing go to trust.com/zigbee

Documents / Resources

Trust ZCTS-808 Zigbee Wireless Contact Sensor [pdf] User Manual
ZCTS-808, Zigbee Wireless Contact Sensor, ZCTS-808 Zigbee Wireless Contact Sensor, Wireless Contact Sensor, Contact Sensor, Sensor

References

Leave a comment

Your email address will not be published. Required fields are marked *