TRIKDIS FLEXi SP3 Smart Security System
Safety precautions
Power supply must be unplugged during installation!
The panel is not resistant to vibrations, other mechanical effects, humidity and aggressive chemical environments. The control panel complies with the demands applicable to Class II environmental specification of the EN 50131 standard.
The casings, transformers, batteries and programming equipment used must meet the safety requirements of the EN 60950 standard. The device is powered from a 110-230 V voltage 50-60 Hz frequency power grid through a Class II step-down 40VA transformer that reduces the voltage to 16 – 18 V or from a 16 – 24 V DC power supply unit. A 12 V battery with at least 7 Ah capacity is used as a backup power supply. The current consumption depends on the power of the connected external devices.
Technical Support
- support@trikdis.lt
- +370 674 22877
Contacts
- info@trikdis.lt
- prekyba@trikdis.lt (for orders)
- www.trikdis.com
INSERT SIM
CONNECTION
Connect antenna
Connect sensors
See how to connect a system with default settings on the other side. (No programming required.)
Power supply must be unplugged during installation!
Connect power supply
Wait 1 min foe LED indication
Download and install app
Other information
LED indication 
WIRING INSTRUCTION
Documents / Resources
 |
TRIKDIS FLEXi SP3 Smart Security System [pdf] Installation Guide FLEXi SP3, FLEXi SP3 Smart Security System, Smart Security System, Security System |
