TRIANGLE S02 HiFi Speaker Stand
Product Information
- Product Name: S02 Stand
- Manufacturer: Triangle Hi-Fi
- Origin: France
- Assembly Location: China
Contact Information
- Address: 475 avenue flandres Dunkerques 02200 Villeneuve saint Germain – FRANCE
- Website: www.trianglehifi.com
- Support & FAQ: www.trianglehifi/support
- Facebook: facebook.com/trianglehifi
- Twitter: twitter.com/trianglehifi
ASSEMBLY OF S02 STAND
- Route the speaker cables through the dedicated holes.
- Attach the spikes on the bottom plate. Use the provided nuts to adjust the spikes for alignment with your floor. If necessary, use the dedicated floor protectors.
Holes for cable management
- Fasten the bottom plate to the tubes. Note that the two tubes are not identical, so assemble them exactly as per the provided schema.
- Secure the top plate to the tubes. To ensure proper alignment, engage the 8 screws without fully tightening them. After this step, check if all parts are well aligned before final screwing.
In order to assur a perfect alignment of the different parts, it is advised to engage the 8 screws without screwing them all the way. Once this step done, check if the different parts are well aligned before final screwing.
www.trianglehifi.com
SITE INTERNET/WEBSITE
www.trianglehifi/support
SUPPORT & FAQ
facebook.com/trianglehifi
twitter.com/trianglehifi
DESIGN BY TRIANGLE HI-FI IN FRANCE – ASSEMBLED IN CHINA
Documents / Resources
 |
TRIANGLE S02 HiFi Speaker Stand [pdf] Installation Guide S02 HiFi Speaker Stand, S02, HiFi Speaker Stand, Speaker Stand, Stand |