Product Information
Specifications
- Model: CCD-0010207
- Revision: 5.14.2025
Product Usage Instructions
Installation
1. Ensure that all components are included in the package.
2. Follow the provided installation guide step by step.
3. Securely connect all cables and components as instructed.
Operation
1. Power on the device using the designated power button.
2. Follow the user manual for specific operation
instructions.
3. Adjust settings as needed for your use case.
Maintenance
1. Regularly clean the product to prevent dust buildup.
2. Check for software updates periodically.
3. Contact customer support for any technical issues.
FAQ
Q: What should I do if the device fails to power on?
A: Check the power source and connections to ensure everything
is properly set up. If the issue persists, contact customer
support.
Q: How often should I clean the product?
A: It is recommended to clean the product every month or as
needed, depending on the operating environment.
Typical Installation-Related Failures
This list includes the most typically seen issues, and is, by no means, intended to be all-inclusive.
9 Leaks at fittings (hose side) 9 Leaks at fittings (o-ring side) 9 Leaks at expansion valve (hose side) 9 Loose fittings 9 Poor hose routing (chaffing, cuts etc.) 9 Hose not secured properly 9 Too much tension on refrigerant. hose (no service loop) 9 Missing or cut o-rings 9 Improper belt alignment 9 Improperly installed mounts (spacers, torque, etc.) 9 Missing compressor shims 9 Loose bolts or hardware 9 Loose electrical connections 9 Incorrect electrical hook-up 9 Poor electrical routing (chaffing, cuts etc.) 9 Cross wiring between systems 9 Cross piping between systems 9 Incorrect piping hook-up 9 Kinked drain hoses 9 Drain hoses running uphill 9 Evaporator not tilted properly 9 Missing, or too little insulation on evaporator refrigerant hoses 9 Condenser not mounted flush to skirt 9 Low voltage to components. (12.5VDC minimum) 9 Leaking roof rail seal 9 Obstructions that limit air flow 9 Structural integrity of mounting area for condenser or evaporator 9 Any interference between any a/c component and OEM components
CCD-0010207 Rev: 5.14.2025
Documents / Resources
 |
Trans Air CCD-0010207 Typical Installation Related Failures [pdf] Installation Guide CCD-0010207, CCD-0010207 Typical Installation Related Failures, CCD-0010207, Typical Installation Related Failures, Related Failures, Failures |