TraceableLIVE logoTraceableLIVE™ QUICK START GUIDE

Thermometer App

  1. Create Account
    Visit https://www.traceablelive.com
    Click on New Account.TraceableLIVE Thermometer App
  2. Enter Account/User
    Information
    Fill in all required fi elds.
    Note: Password must be a minimum of 8 characters including a number and a special character (!@#$%^&*).TraceableLIVE Thermometer App - fig
  3. Enter Payment Info./ Confi rm ChargeTraceableLIVE Thermometer App - fig 2If this screen does not appear, go to log in screen, account settings and add payment information.
    Note: Payment must be set up prior to adding a device to your service.
    Click Save Payment Info
  4. Begin WiFi SetupTraceableLIVE Thermometer App - fig 3On device Press/HOLD WiFi button for 3 secs.
    TraceableLIVE Thermometer App - fig 4” will appear on display.
    Wait for a few seconds then press (no need to hold) WiFi button, “TraceableLIVE Thermometer App - fig 8 ” will appear on display.TraceableLIVE Thermometer App - fig 95 Commonwealth Ave Woburn, MA 01801 Phone 781-665-1400 Toll Free 1-800-517-8431
  5. Connect Unit to WiFi network via Mobile deviceTraceableLIVE Thermometer App - fig 10Using a WiFi enabled device (smart phone, tablet, etc.), find CC6500-XXXX in available networks.
    XXXX will be last 4 digits of unit’s S/N# (on back of unit).
    TraceableLIVE Thermometer App - fig 12
  6. Open Web Browser on your mobile deviceTraceableLIVE Thermometer App - fig 14Enter into web browser: 192.168.1.1
    Select desired local network to which the device will be connected, and enter password for network. The most common network is WPA2.
  7. Press Add/Confirm device restart
    Click AddTraceableLIVE Thermometer App - fig 13Unit will reboot, connect to WiFi, and begin posting data.
    Note: Upon successful connection, you will recieve an error message in your browser (Example: Safari cannot open the page because the network connection was lost.), and device reboot may take up to 1 minute, mobile will exit WiFi.
    Note: The WiFi symbol will flash on device display until the device posts data successfully.
    Note: ALLOW UP TO 30 MINS FOR DEVICE DATA TO UPDATE AND START TRANMITTING DATA.
    If and ERR message occurs on device, press acknowledge button (√ ) and repeat steps 4-7.
    Log-in to TraceableLIVE account to manage device settings, alarms, users, and payment options.
  8. Enter Device Information (located on back of unit)
    Go to www.traceablelive.com Click on Add New DeviceTraceableLIVE Thermometer App - fig 16Complete all required fields.
    Enter S/N & Device Key traceable.com 281-482-1714 By: 100 Due: Nov, 19 2017 Device and account setup is now complete.TraceableLIVE Thermometer App - fig 17

Documents / Resources

TraceableLIVE Thermometer App [pdf] Instruction Manual
WD-99460-10, App

References

Leave a comment

Your email address will not be published. Required fields are marked *