tp-link tapo Instruction Manual
Getting Started
1. Get the Tapo app from the Apple App Store or Google Play.
2. Follow the instructions in the Tapo app to complete the setup.
Supported Load Type for UK Version:
220-240Vac, 50/60Hz, 13A Resistive Load
220-240Vac, 50/60Hz, 2.0FLA/13LRA*, Motor Load
*FLA=Full Load Ampere; LRA=Lock Rotor Ampere
Support
For technical support, the user guide and other information, please visit https://www.tapo.com/support/, or simply scan the QR code.
TP-Link hereby declares that the device is in compliance with the essential requirements and other relevant provisions of directives 2014/53/EU, 2009/125/EC, 2011/65/EU and (EU) 2015/863. The original EU declaration of conformity may be found at https://www.tapo.com/support/ce/.
Safety Information
• Keep the device away from water, fire, humidity or hot environments.
• Do not attempt to disassemble, repair, or modify the device.
• Do not use the device where wireless devices are not allowed.
• The socket-outlet shall be installed near the equipment and shall be easily accessible
• The devices are not intended for use in locations where the temperature may be less than actual room conditions, such as unheated warehouses or garages.
• For passthrough devices, plug the power strips into the integrated electrical sockets of the devices, but devices of the same or another type not be stacked in normal use.
Please read and follow the above safety information when operating the device. We cannot guarantee that no accidents or damage will occur due to improper use of the device. Please use this product with care and operate at your own risk.
Warranty
For more information about warranty, please visit https://www.tapo.com/support/
© 2020 TP-Link
Documents / Resources
 | tapo |
References
- Support | Tapowww.tapo.com
- Regulatory Compliance | Tapowww.tapo.com
- User Manualmanual.tools
Hej Har laddat batteriet och innan det var dags att ladda så ringde en klocka Nu isatt batteri men får den ej på kamera Vad göra
Why is my TP-Link Tapo camera not turning on after charging and reinserting the battery?
If your TP-Link Tapo camera is not turning on after charging and reinserting the battery, please try the following troubleshooting steps:
If the camera remains unresponsive, it may be a hardware failure. You can find further technical support and user guides at https://www.tapo.com/support/.
Note: Based on your description in Swedish, it sounds like the camera signaled a low battery (the "bell" or alert) before you charged it, but now fails to boot up. If the LED does not light up at all after reinsertion, the battery may not be providing a charge.
Swedish Summary: Kontrollera att batteriet sitter ordentligt på plats och att kontakterna är rena. Prova att hålla in Reset-knappen i 5 sekunder för att starta om kameran. Om den fortfarande inte startar, besök TP-Links supportsida för vidare hjälp.
Disclose uncertainty: As the specific model was not mentioned, these are general steps for Tapo battery cameras.
Read the full Q&A page
Miksi minulle ei tule kirjautumisen vahvistus sähköpostia?
Why am I not receiving the login verification email?
If you are not receiving the login verification email for your TP-Link Tapo account, please try the following troubleshooting steps:
no-reply@email.tp-link.comto your contacts or safe senders list to prevent it from being blocked.If you still do not receive the email, you can visit the official support page at https://www.tapo.com/support/ or contact their support team at
app.support@tp-link.com.Read the full Q&A page