TOUGHBUILT TB-B1S3-M-20 2 Shelf System
Specifications
- Product: 2-Shelf System
- Model: TB-B1S3-M-20
Assembly Instructions
Before assembling and using this product, please read and follow the instructions carefully.
Package Contents
- A x 2
- D x 2
- B x 4
- C x 8
Required Tools (Not Included)
You will need the following tools for assembly (not included in the package):
- Appropriate Mounting Hardware for Wall Material Type
Warnings and Cautions
- WARNING: Wear safety goggles and proper apparel when assembling and using this product. Avoid distraction and keep pets and children away from the work area.
- WARNING: E-Tracks (D) must be properly anchored and able to support a 100 lb. load. Use appropriate mounting hardware for wall material type.
- WARNING: DO NOT step on the shelves.
- CAUTION: 50 lb maximum load per shelf. Distribute weight evenly and place heavier loads on the bottom shelf.
- CAUTION: Stabilize the shelves to E-Tracks (D) by tightening bolts.
- CAUTION: DO NOT alter this product in any manner.
IMPORTANT!
READ ALL SAFETY WARNINGS AND ALL INSTRUCTIONS BEFORE USING. THE SPECIFICATIONS AND GENERAL APPEARANCE ARE SUBJECT TO CHANGE WITHOUT NOTICE AND WITHOUT OBLIGATION BY TOUGHBUILT® INDUSTRIES, INC. AND MAY DIFFER FROM THOSE APPEARING IN THIS MANUAL.
Assembly Instructions
Install E-Tracks
E-Tracks (D) must be properly anchored and able to support a 100 lb. load.
Wall-mounting hardware is not included. Use appropriate mounting hardware for the wall material type. If needed, consult a professional for assistance.
Assemble Shelves
Follow the steps below to assemble the shelves:
- Place two A pieces parallel to each other.
- Attach two B pieces to the ends of the A pieces.
- Attach four C pieces to the corners of the A and B pieces.
Install Shelves
Follow the steps below to install the shelves:
- Hold the D tab on the E-Track (D).
- Position the assembled shelf on top of the E-Track (D) with the D tab inserted into the corresponding slot.
Secure Shelves
Follow the steps below to secure the shelves:
- Tighten the bolt until it contacts the E-Track (D). DO NOT overtighten.
- To remove the shelf, loosen the bolt.
- Loosen bolt to remove the shelf.
2-SHELF SYSTEM | TB-B1S3-M-20
Copyright © Tough Built Industries Inc. 2023
Documents / Resources
 |
TOUGHBUILT TB-B1S3-M-20 2 Shelf System [pdf] Instructions TB-B1S3-M-20 2 Shelf System, TB-B1S3-M-20, 2 Shelf System, System |
