T10 PPPoE DHCP static IP settings

It is suitable for: T10

Application introduction:

Solution about how to configure Internet mode with PPPoE ,Static IP and DHCP for TOTOLINK products

Diagram

Diagram

Set up steps

STEP-1:

Connect your computer to the router by cable or wireless, then login the router by entering http://192.168.0.1 into the address bar of your browser.

STEP-1

Note:

The default access address varies depending on the actual situation. Please find it on the bottom label of the product.

STEP-2:

User Name and Password are required, by default both are admin in lowercase letter. Click LOGIN.

STEP-2

STEP-3.1.1: Easy Setup DHCP setting

The Easy Setup page will turn up for basic and quick setting,Select DHCP as WAN Connection Type, then Click Apply.

STEP-3

STEP-3.1.2: Advanced Setup DHCP setting

Please go to Network ->WAN Setting page, and check which you have selected.

Select DHCP Client as WAN Type, then Click Apply.

DHCP Client

STEP-3.2.1: Easy Setup Static IP setting

The Easy Setup page will turn up for basic and quick setting,Selecting Static IP as WAN Connection Type and input your information about Static IP which you want to fill in .Then Click Apply.

Static IP

STEP-3.2.2: Advanced Setup Static IP setting

Please go to Network ->WAN Setting page, and check which you have selected.

Select Static IP as WAN Type and input your information about Static IP which you want to fill in .

Then Click Apply.

Apply

STEP-3.3.1: Easy Setup PPPOE setting

The Easy Setup page will turn up for basic and quick setting ,Select PPPoE as WAN Type and input your PPPoE username and password which are provided by your ISP. Then Click Apply

PPPoE 

STEP-3.3.2: Advanced Setup PPPOE setting

Please go to Network ->WAN Setting page, and check which you have selected.

Select PPPoE as WAN Type and input your PPPoE username and password which are provided by your ISP. Then Click Apply.

WAN Type

 

References

Leave a comment

Your email address will not be published. Required fields are marked *