A2004NS repeater setting
It is suitable for: A1004 / A2004NS / A5004NS / A6004NS
Application introduction: Solution about how to set repeater mode on TOTOLINK products.
STEP-1: Connect your computer to the router
1-1. Connect your computer to the router by cable or wireless, then login the router by entering http://192.168.1.1 into the address bar of your browser.
Note:The default access address differs by model. Please find it on the bottom label of the product.
1-2. Please click Setup Tool icon 
to enter the router’s setting interface.
1-3. Please login to the Web Setup interface (the default user name and password is admin).
STEP-2: Wireless(2.4GHz) repeater setting
Please go to Advance Setup ->Wireless(2.4GHz)->Wireless Multibridge , and check which you have selected.
Select Use Wireless Bridge and WPAPSK/WPA2PSK+TKIP/AES in Encryption, then Click AP Scan.
Then select the host router’s SSID and way of Encryption ,then input password of the host router’s SSID and Click Apply.
STEP-3: Wireless(5GHz) repeater setting
Please go to Advance Setup ->Wireless(5GHz) ->Wireless Multibridge , and check which you have selected.
Select Use Wireless Bridge in Mode and WPAPSK/WPA2PSK+TKIP/AES in Encryption, then Click AP Scan.
Then select the host router’s SSID and way of Encryption ,then input password of the host router’s SSID and Click Apply.
PS: After completing the above operation, please re-connect your SSID after 1 minute or so. if the Internet is available it means thatthe settings are successful. Otherwise, please re-set the settings again
DOWNLOAD
A2004NS repeater setting – [Download PDF]
