TORK 652918 Level Sensor 3.0

Warnings

• Do not modify the sensor in any way (including painting it).
• Do not expose battery to high tempera-tures, disassemble it, damage it mechanically, or put battery into fire as this can cause an explosion.
• Do not replace battery with an incor-rect type as this can cause an explo-sion.
• Avoid touching sensor area of the sensor as doing this can affect the performance of the sensor.
• If any of the components appear to be damaged or broken, contact Essity.

Labeling symbols

The following symbols appear on your packing:

• UK Conformity mark
• European Conformity mark
• WEEE-marking
• This product has been designed with recycling, reuse and waste management in consideration. Essity will provide the necessary information to recycling facilities and government agencies as required by WEEE Directive. For more information, please contact the manu-facturer at www.tork/global.com.
• The product will be labeled with the WEEE mark as shown on the side, in accordance with European Standard EN 50419.
• The proper disposal of WEEE products will conserve natural resources (through reuse and recycling) and protect environ-mental and human health through proper disposal.
• WEEE-labeled products must be kept separate and returned to a designated collection point for dismantling, recycling and/ or reuse.
• The separate collection and recycling of your waste equipment at the time of disposal will help to conserve natural resources and ensure that it is recycled in a manner that protects human health and the environment. For more information about where you can drop off your waste equipment for recycling, please contact your local government, your commercial, institutional and/ or municipal waste disposal service or the location where you purchased the product.

Technical specifications

• Simplified Declaration of Conformity
  • Hereby, Essity Hygiene and Health AB declares that the radio equipment Level Sensor 3.0 is in compliance with Directive 2014/53/EU. The full text of the EU declaration of conformity is available at the following internet address:
    www.torkglobal.com
• Simplified UK Declaration Of Conformity
  • Hereby, Essity Hygiene and Health AB declares that the radio equipment Level Sensor 3.0 is in compliance with Radio Equipment Regulations 2017. The full text of the UK declaration of conformity is available at the following internet address: www.torkglobal.com
• Find product information and the full EU and UK Declaration of Conformity at: www.torkglobal.com

Note;This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installa-tion. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interfe-rence by one or more of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.

Warning: Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate this equipment.
This device contains license-exempt transmitter(s)/ receiver(s) that comply with Innovation, Science and Economic Development Canada’s license-exempt RSS(s). Operation is subject to the following two conditions:

1. This device may not cause interference.
2. This device must accept any interference, including interference that may cause undesired operation of the device.

FCC STATEMENT

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:

1. this device may not cause harmful interference,
2. this device must accept any interference received, including interference that may cause undesired operation.

necessity

• Manufactured by Essity Hygiene and Health AB
• SE-405 03  Sweden
• Visiting address:

For UK:

• Essity UK Limited
• Southfields Road
• Dunstable
• Bedfordshire
• LU6 3EJ, UK
• +44 1582 677400

For North America:

• Distributed by Essity HMS
• North America Inc
• 2929 Arch Street
• Suite 2600
• Philadelphia, PA 19104

www.essity.com,
www.torkglobal.com

Made in Sweden

Documents / Resources

	TORK 652918 Level Sensor 3.0 [pdf] User Manual 2ABK3-652918, 2ABK3652918, 652918 Level Sensor 3.0, 652918, Level Sensor 3.0, Sensor 3.0, Sensor
	TORK 652918 Level Sensor 3.0 [pdf] User Manual TVC 2ABK3-652918, 2ABK3652918, 652918 Level Sensor 3.0, 652918, Level Sensor 3.0, Sensor 3.0, Sensor

References

• User Manual