UltraDiag
Quick User Guide

Getting Started

1. Register & log in
   Turn on the UltraDiag tablet and log in to your TOPDON account. (If you do not have an account, please register with your email.)
2. Plug the UltraDiag VCI into the vehicle’s DLC
   The vehicle’s DLC is usually located under the dashboard.
3. Turn the ignition to the “ON” position
4. Bind the UltraDiag VCI
   ① Go to User Info > VCI Management. Tap the + icon at the top right corner of the screen, and the device will ask you to connect the Bluetooth first.
   ② Connect the Bluetooth as prompted. Then the serial number and activation code will be automatically obtained (see Figure 1).
   Then tap Activate to bind the UltraDiag VCI.
5.  Connect the UltraDiag VCI to the UltraDiag tablet
   The UltraDiag VCI can be connected to the UltraDiag tablet either via wireless (Bluetooth) or wired connection (USB cable) (see Figure 2).
   : UltraDiag VCI is successfully connected via Bluetooth
   : UltraDiag VCI is successfully connected via USB cable
6. Your UltraDiag is now ready for use

UltraDiag Tablet

1 .Eight-Inch Touch Screen 2. Reset Button 3. Power Button 4. 3.5 mm Audio Port 5. RJ45 Port 6. USB Type-A Port 7. 12V DC Power Supply Input Port 8. HDMI Port

9. USB Type-C Port 10 Screenshot Button 11. Mic 12. TF Card Expansion Slot 13. VCI Slot 14. Camera Lens 15. Audio Speaker 16. Collapsible Stand

1. Flashing Green: communicating with the vehicle
2. Solid Red: power on
3. Solid Blue: Bluetooth connected
4. USB Type-C Port
5. OBD-II 16 Pin Connector

Multilingual User Manual
Thanks for purchasing the UltraDiag automotive diagnostic tool. This quick user guide will  walk you through the basic setup and operation of UltraDiag. Please carefully read all theinstructions before use. For further information, please download the detailed user manual via www.topdon.com/products/ultradiag or through the QR code below.

• For detailed user manual, please scan the QR code below.

http://www.topdon.com/products/ultradiag

TEL	86-755-21612590 1-833-629-4832 (North America)
EMAIL	SUPPORT@TOPDON.COM
WEBSITE	WWW.TOPDON.COM
FACEBOOK	©TOPDONOFFICIAL
TWITTER	©TOPDONOFFICIAL

*This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. *Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

Documents / Resources

TOPDON UltraDiag 2 in 1 Diagnostic Scanner and Key Programmer [pdf] User Manual UltraDiag 2 in 1 Diagnostic Scanner and Key Programmer, UltraDiag, 2 in 1 Diagnostic Scanner and Key Programmer, Diagnostic Scanner and Key Programmer, Scanner and Key Programmer, Key Programmer, Programmer

References

• User Manual