Wireless Microphone, TONOR UHF Metal Cordless Handheld Mic System with Rechargeable Receiver-Complete Features/Instruction Manual

One of the most decent Microphone with upgraded high-quality cardioid microphone with excellent feedback suppression. The Tonor Microphone is the operate from the distance around 200ft range. The Tonor wireless microphone is suitable for indoor and outdoor activities, weddings events, conferrence, etc. The Tonor Wireless microphone is very easy to operate you just turn on the signal and receiver will sync frequency automatically. And Tonor Microphone give you 15 adjustables channels that you easily operate.The Tonor microphone has a rechargeable battery and protable receivers that only needs to charge 2 -3 hours and used for almost 6-7 hours. Tonor microphone has a good battery timing.

What’s in the box?

1 x handheld microphone,

1 x receiver with a 6.35mm plug,
1 x anti-slip ring,

1 x mic cover,
1 x USB charging cable

1 x manual.
Note: 2 AA batteries are required (not included).

ACCESSORIES

OPERATING ENVIRONMENTS & NOTES

When using this device, keep it away from water.
Use the device in ventilated environment, keep it away from fire.

Since it’s a wireless device, please keep it away from other interfering sources.
Don’t take apart the device.

Please use the standard power supply, high voltage may damage the device.
Please place the used batteries into the recycle bin, don’t litter them.

MICROPHONE OPERATION INSTRUCTION

As shown in above pictures:

Display Screen
On/Off Switch

Tail Tube
HI-LO Button
Battery Compartment

Install 2-AA batteries before using the wireless microphone and installing instruction is as follows:

Take down the tail tube of mic.
Install the batteries and , tighten tail tube of mic.

Note: The positive and negative polarity of battery cannot be reversed.

Instruction:

Press buttonQ) for 2s to turn it on/off.
Press the HI-LO button@, then the frequency on the screen will be changed.

RECEIVER INSTRUCTION

POWER BUTTON
USB CHARGING PORT
SIGNAL ANTENNA

BATTERY INDICATOR
RF LIGHT

LIGHT INSTUCTION

Battery indicator@	Turns red and flashes quickly	The power of the receiver is in a low battery status.
	Stays on	The receiver is in charging model.
	Turns off	The receiver is fully charged.
RF light@	Flashes slowly	The receiver is not connected to the microphone.
	Stays on	The receiver and microphone are successfully connected.
	Flashes quickly	The receiver and microphone are successfully connected, and the microphone is transmitting audio signals.

TROUBLESHOOTING

Problem

Solution

No sound

(The batteries of microphone have already been installed, but the RF light (green) still flashes slowly.)

Wireless Microphone ID Pairing Steps:

1. Make sure that the receiver and microphone are turned OFF.

2. Unscrew the microphone tail tube and install the batteries into the mic’s battery compartment.

3. Make sure that the microphone is OFF, press and hold the HI/LO button @ and the power button @ simultaneously, do not release them, until the microphone screen flashes quickly, then release two buttons simultaneously.

4. Turn on the receiver’s power button, wait for 5 seconds or so, then press the HI/LO button@ (on the microphone) once, until the microphone screen becomes steady and no longer flashes, the RF light an the receiver turns steady, indicating that the pairing is successful.

5. Turn off the microphone, then tighten the microphone tail tube. Pairing is now completed.

Problem

Solution

Received signal with noise or interference

Change to other channels;

Check if receiving distance exceeds the maximum range.

Microphone cannot be turned on

Check if batteries are installed reversely;

Change to new batteries.

Frequently Asked Questions

Microphone will not turn on
New batteries might be necessary, you have to unscrew the bottom. Also, if the plug for the speaker is dead it will cut off so that might need charging.

Does this mic come with a foam wind screen; or is the mic cover supplied rather like a case?
This microphone comes with a foam mic cover.
How to replace receiver battery.
Hello, the receiver is rechargeable and no need to replace the battery. It only needs to charge for about 2-3 hours, and it can be used for 6-8 hours.
Build in rever effect?
No, there is no reverb effect. You can use a mixer or amplifier with the reverb function to realize the effect you want.

Will this microphone work on an ion tailgater flash bluetooth speaker ipa88? any feed back issues with blue tooth speakers?
If the mic port on the device is 6.35mm, you will be able to use use the microphone with it.
Is this good for sideline reporting?
yes it is really good for sideline reporting.
Can I use this on a camera as a wireless microphone or connect to a phone?
TW-620 is a kind of microphone especially for mixer/amp/speaker/karaoke machine; it does not support the camera and phone.

If rechargeable battery in the portable receiver lasts 6-8 hours… how long will 2AA batteries in handheld microphone last, longer than 6-8 hours?
Generally speaking, it will last above 12 hours if using the good AA battery, similar to the NanFu battery from China. But it is recommended for you to use the rechargeable battery because it is not durable after several-charging.
Will music still play while someone is talking on the mic ?
Sure. Music can play while someone is talking on the mic.
Is this a good mic for hosting ?
Yes, the operating range of this microphone is about 200 ft (line of sight), which is suitable for indoor and outdoor activities, such as home karaoke, church, wedding, conference, and small stage performances.

Is it suitable for home karaoke?
Yes, it is suitable for home karaoke or stage performance. The TW-620 focuses on the details of the sound, it accentuates the warmth and clarity of vocals (bright midrange and strong bass), and it adopts built-in feedback suppression technology. Even placing the microphone near the speaker will not cause howling, may only have a slight pop sound
Mic has no sound brand new! No response since purchased December all connected and absolutely nothing. Why is the mic not working?
It has to be charged.
If it’s a BIG party, with the receiver plugged into a sound mixing board, will the signal go around the people to get to the microphone?
Yeah, of course. And the meters of coverage reaches 60 meters, so it can be used in big partys.

Does the mike have an off switch so that I can turn it off when it’s not needed?
Yes, there is a power button to turn if off.
Is this considered a dynamic mic
I believe this mic is a cardioid condenser microphone designed for vocals

View Fullscreen

References

User Manual

Wireless Microphone, TONOR UHF Metal Cordless Handheld Mic System with Rechargeable Receiver

Specifications