tis control OS-MMV2-IC Radar Sensor
Product Specifications
- Wave: Radar
- Frequency: 24GHz Millimeter Wave Radar
- Light Intensity: Lux meter, 0-5000 Lux
- Temperature Sensor: Resistance Temperature Sensor
- Number of Devices on 1 Line: Max. 64
- Bus Voltage: 12-32 V DC
- Current Consumption: Not specified
Installation
- Choose a suitable location for mounting the sensor on the ceiling.
- Ensure the power supply meets the required voltage range (12-32 V DC).
- Mount the sensor securely using appropriate fixtures and follow the wiring instructions provided.
Operation
The TIS Radar Sensor detects occupancy in the area it covers using radar technology. It can be programmed to optimize energy consumption based on occupancy patterns.
Programming
Refer to the user manual for detailed instructions on programming the sensor to optimize energy consumption.
Maintenance
Regularly inspect the sensor for any physical damage or obstructions that may affect its performance. Clean the sensor periodically to ensure accurate detection.
PRODUCT INFORMATION
- The TIS Radar Sensor is designed for applications where occupancy detection is essential. It can also be programmed to optimize energy consumption.
PRODUCT SPECIFICATIONS
Read Instructions
- We recommend that you read this Instruction Manual before installation.
Safety instructions
- Electrical equipment should only be installed and fitted by electrically skilled persons.
- Failure to follow the instructions may cause damage to the device and other hazards. These instructions are an integral part of the product and must remain with the end customer.
Programming
- Advanced programming requires knowledge of the TIS Device Search software and instruction in the TIS advanced training courses.
Simple Installation
- You can use 2 screws to install this sensor on the ceiling.
Mounting Location
- Install in a dry, indoor area with a suitable temperature and humidity range.
Data Cable
- Use a screened stranded RS-485 data cable with four twisted pairs. Configure devices in a “Daisy Chain.”
- Do not cut or terminate live data cables.
Warranty
- There is a two-year warranty provided by law. The hologram warranty seal and product serial number are available on each device.
INSTALLATION STEPS
- Turn off the TIS power supply
- Create a 50mm hole in the ceiling to fit the sensor properly
- Attach the TIS-BUS cable to the sensor, ensuring a secure connection
- Push the mounting springs upwards with one hand and insert the mounting springs through the hole; then push the sensor until it is fitted into the ceiling
- Push the mounting springs upwards with one hand and insert the mounting springs through the hole; then push the sensor until it is fitted into the ceiling
TROUBLESHOOTING
- Copyright © 2025 TIS, All Rights Reserved
- TIS Logo is a registered trademark of TIS CONTROL.
- All of the specifications are subject to change without notice.
- TIS CONTROL PTY LIMITED
SA, AUSTRALIA - TIS CONTROL LIMITED
Wanchai, Hong Kong - www.tiscontrol.com
Frequently Asked Questions
Q: How can I adjust the sensitivity of the radar sensor?
A: The sensitivity of the radar sensor can usually be adjusted through the programming interface. Refer to the user manual for specific instructions.
Q: What is the maximum coverage area of the sensor?
A: The coverage area of the sensor may vary based on installation height and environment, but generally, it can cover a standard room size.
Documents / Resources
 |
tis control OS-MMV2-IC Radar Sensor [pdf] Installation Guide OS-MMV2-IC, OS-MMV2-IC Radar Sensor, OS-MMV2-IC, Radar Sensor, Sensor |