Meshtastic Series Transceiver Device
Powered By ESP32-S3
User Manual
Device Parts
| 1. LoRa Antenna 2. 1.3’’ OLED 3. Product Status LED 4. Reset Button 5. Type-C Port: 5V/1A |
6. ESP32-S3 Module 7. Power Button 8. Function Button 9. Buzzer 10. BOOT Button |
Quick Guide
- Power Button: Long press to power on or off (release after power on/off is complete)
- Function Button: Single Click: switch screen display pages by single click;
- Double Click: Send a temporary ping of the device’s location to the network;
- Triple Click: Trigger an SOS alarm signal (three short, three long, three short), activate the buzzer, and flash the indicator light;
- BOOT Button: Switch screen display pages by single click.
- Reset button: Click to restart/reboot the device.
- Product Status LED:
a. After the device is turned on normally, the red light stays on steadily.
b. The red light flashes rapidly to indicate charging status, and remains steady when fully charged.
c. When the battery level is low, the red light will flash slowly.
Precautions
- Avoid placing the product in damp or high temperature areas.
- Do not disassemble, impact, crush, or throw the product into fire; do not use after submersion in water.
- If the product shows physical damage or severe swelling, do not continue to use it.
- Do not use an unsuitable power supply to power the device.
Main Specifications
| Product Name | ThinkNode-M2 |
| Dimensions | 88.4*46*23mm (With antenna) |
| Weight | 50g (With enclosure) |
| Screen | 1.3’’ OLED |
| Type-C port | 5V/1A |
| Battery Capacity | 1000mAh |
Documents / Resources
 |
ThinkNode-M2 Meshtastic Series Transceiver Device [pdf] User Manual Meshtastic Series Transceiver Device, Meshtastic Series, Transceiver Device, Device |