RH SPOT™
Operating Instructions
What’s included:
RH SPOT, battery, metal mounting plate w/adhesive backing and this instruction card.
How to operate:
RH SPOT is an ambient temperature and humidity thermometer, primarily used to track temperatures and humidity over time. It is not an instant-read thermometer. Display will change between temperature and humidity every 5 seconds.
- To power on RH SPOT, press
once. - To activate backlight, press . Backlight stays on for 10 seconds.
- To power off RH SPOT, press and hold for 5 seconds.
- Press and hold for 3 seconds, MAX temperature will show in the display. Press again, MIN temperature will show in the display. Press again, MAX humidity will show in the display. Press again to view MIN humidity.
- To switch from °F to °C, press and hold for 5 seconds upon start up.
To Change Battery:
- Replace with 3-volt, CR2032 button cell battery. Use a phillips screwdriver to open the battery cover on the bottom. Install the battery according to the correct polarity, positive side up. sliding the battery under the metal clip. Reattach the battery cover.
For service or warranty:
385-330-0591
techsupport@thermoworks.com
Important Humidity Ranges
Normal Room Range
30 to 60%
Cheese Cave Range
75 to 99%
Wine Storage
50 to 70%
Bread Proofing Range
80 to 85%
Terrarium Range
Above 50%
Humidor Range
65 to 72%
Food Storage Range
50 to 55%
Bikram Yoga
40%
www.thermoworks.com
741 E. Utah Valley Dr.
American Fork, UT 84003
P-19-012-02-a
Documents / Resources
 |
ThermoWorks RH SPOT Temperature and Humidity Thermometer [pdf] Instruction Manual RH SPOT, Temperature and Humidity Thermometer, RH SPOT Temperature and Humidity Thermometer, Humidity Thermometer, Thermometer |
