The Retro Web DE-100TP D-LINK Network Interface Card

Specifications

• NIC Type: D-LINK DE-100TP
• Transfer Rate: Ethernet 10Mbps
• Data Bus: 8-bit ISA
• Topology: Linear Bus
• Wiring Type: Shielded/Unshielded twisted pair AUI transceiver via DB-15 port
• Boot ROM: Available

Product Usage Instructions:

Jumper Settings
Make sure to set the jumpers according to the specified configurations for proper functionality.
Boot ROM Setting
Configure the Boot ROM settings by closing or opening the specified pins as indicated in the manual.

Diagnostic LEDs

• LED1: Status On – Power is on
• LED1: Blinking On – Data is being transmitted
• LED2: Blinking On – Data is being received
• LED3: On – Network connection is good
• LED4: Off – No collisions detected on the network

I/O Base Address Configuration:
Set the I/O base address by positioning the pins as specified in the manual for the desired address.

FAQ:

1. What should I do if the diagnostic LED indicates a collision on the network?
   If a collision is detected, check for any network issues or interference. Ensure proper cable connections and network stability.
2. How can I verify if data is being transmitted successfully?
   Monitor the LED indicators; if LED1 is blinking, it indicates data transmission. Additionally, check for any error messages on your connected devices.

THE NETWORK INTERFACE CARD TECHNICAL GUIDE
D-LINK
DE-100TP for PC/XT/AT

• NIC Type Ethernet
• Transfer Rate 10Mbps
• Data Bus 8-bit ISA
• Topology Linear Bus
• Wiring Type Shielded/Unshielded twisted paiAUI transceiver via DB-15 port
• Boot ROM Available

	BOOT ROM ADDRESS
Address                                  JP5A                                      JP5B                                     JP5C
C0000h		Pins 1 & 2 Closed	Pins 1 & 2 Closed	Pins 1 & 2 Closed
C4000h		Pins 2 & 3 Closed	Pins 1 & 2 Closed	Pins 1 & 2 Closed
C8000h		Pins 1 & 2 Closed	Pins 2 & 3 Closed	Pins 1 & 2 Closed
CC000h		Pins 2 & 3 Closed	Pins 2 & 3 Closed	Pins 1 & 2 Closed
íD0000h		Pins 1 & 2 Closed	Pins 1 & 2 Closed	Pins 2 & 3 Closed
D4000h		Pins 2 & 3 Closed	Pins 1 & 2 Closed	Pins 2 & 3 Closed
D8000h		Pins 1 & 2 Closed	Pins 2 & 3 Closed	Pins 2 & 3 Closed
DC000h		Pins 2 & 3 Closed	Pins 2 & 3 Closed	Pins 2 & 3 Closed

	CABLE TYPE
Type                                                                             JP1A – JP1F
íShielded/Unshielded twisted pair		Pins 1 & 2 Closed
AUI Transceiver via DB-15 port		Pins 2 & 3 Closed

	INTERRUPT REQUEST
IRQ		JP3A	JP3B	JP3C	JP3D	JP3E	JP3F
2		Closed	Open	Open	Open	Open	Open
í3		Open	Closed	Open	Open	Open	Open
4		Open	Open	Closed	Open	Open	Open
5		Open	Open	Open	Closed	Open	Open
6		Open	Open	Open	Open	Closed	Open
7		Open	Open	Open	Open	Open	Closed

	BOOT	ROM		SETTING
Setting				JP2
íDisabled			Pins 1 & 2 Closed
Enabled			Pins 2 & 3 Closed

	DMA
DMA		JP4A & JP4E	JP4B & JP4F	JP4C & JP4G	JP4D & JPH
íDisabled		Open	Open	Open	Closed
1		Closed	Open	Closed	Open
2		Open	Closed	Open	Closed
3		Open	Open	Closed	Open

	BOOT ROM ADDRESS
Address                                  JP5A                                      JP5B                                     JP5C
C0000h		Pins 1 & 2 Closed	Pins 1 & 2 Closed	Pins 1 & 2 Closed
C4000h		Pins 2 & 3 Closed	Pins 1 & 2 Closed	Pins 1 & 2 Closed
C8000h		Pins 1 & 2 Closed	Pins 2 & 3 Closed	Pins 1 & 2 Closed
CC000h		Pins 2 & 3 Closed	Pins 2 & 3 Closed	Pins 1 & 2 Closed
íD0000h		Pins 1 & 2 Closed	Pins 1 & 2 Closed	Pins 2 & 3 Closed
D4000h		Pins 2 & 3 Closed	Pins 1 & 2 Closed	Pins 2 & 3 Closed
D8000h		Pins 1 & 2 Closed	Pins 2 & 3 Closed	Pins 2 & 3 Closed
DC000h		Pins 2 & 3 Closed	Pins 2 & 3 Closed	Pins 2 & 3 Closed BOOT ROM ADDRESS Address                                  JP5A                                      JP5B                                     JP5C C0000h Pins 1 & 2 Closed Pins 1 & 2 Closed Pins 1 & 2 Closed C4000h Pins 2 & 3 Closed Pins 1 & 2 Closed Pins 1 & 2 Closed C8000h Pins 1 & 2 Closed Pins 2 & 3 Closed Pins 1 & 2 Closed CC000h Pins 2 & 3 Closed Pins 2 & 3 Closed Pins 1 & 2 Closed íD0000h Pins 1 & 2 Closed Pins 1 & 2 Closed Pins 2 & 3 Closed D4000h Pins 2 & 3 Closed Pins 1 & 2 Closed Pins 2 & 3 Closed D8000h Pins 1 & 2 Closed Pins 2 & 3 Closed Pins 2 & 3 Closed DC000h Pins 2 & 3 Closed Pins 2 & 3 Closed Pins 2 & 3 Closed

	DIAGNOSTIC LED(S)
LED                       Status                                                               Condition
LED1		On	Power is on
LED1		Blinking	Data is being transmitted
LED2		On	Network connection is good
LED2		Blinking	Data is being received
LED3		On	Collision detected on the network
LED3		Off	No collisions detected on the network
LED4		Off	Normal operation
LED4		On	Transmission interrupted due to abnormally long data stream output

	I/O BASE ADDRESS
Address                 JP6A                       JP6B                       JP6C                       JP6D                       JP6E
100h		Pins 1 & 2	Pins 2 & 3	Pins 1 & 2	Pins 1 & 2	Pins 1 & 2
120h		Pins 1 & 2	Pins 2 & 3	Pins 1 & 2	Pins 1 & 2	Pins 2 & 3
140h		Pins 1 & 2	Pins 2 & 3	Pins 1 & 2	Pins 2 & 3	Pins 1 & 2
160h		Pins 1 & 2	Pins 2 & 3	Pins 1 & 2	Pins 2 & 3	Pins 2 & 3
180h		Pins 1 & 2	Pins 2 & 3	Pins 2 & 3	Pins 1 & 2	Pins 1 & 2
1A0h		Pins 1 & 2	Pins 2 & 3	Pins 2 & 3	Pins 1 & 2	Pins 2 & 3
1C0h		Pins 1 & 2	Pins 2 & 3	Pins 2 & 3	Pins 2 & 3	Pins 1 & 2
1E0h		Pins 1 & 2	Pins 2 & 3	Pins 2 & 3	Pins 2 & 3	Pins 2 & 3
200h		Pins 2 & 3	Pins 1 & 2	Pins 1 & 2	Pins 1 & 2	Pins 1 & 2
220h		Pins 2 & 3	Pins 1 & 2	Pins 1 & 2	Pins 1 & 2	Pins 2 & 3
240h		Pins 2 & 3	Pins 1 & 2	Pins 1 & 2	Pins 2 & 3	Pins 1 & 2
260h		Pins 2 & 3	Pins 1 & 2	Pins 1 & 2	Pins 2 & 3	Pins 2 & 3
280h		Pins 2 & 3	Pins 1 & 2	Pins 2 & 3	Pins 1 & 2	Pins 1 & 2
2A0h		Pins 2 & 3	Pins 1 & 2	Pins 2 & 3	Pins 1 & 2	Pins 2 & 3
2C0h		Pins 2 & 3	Pins 1 & 2	Pins 2 & 3	Pins 2 & 3	Pins 1 & 2
2E0h		Pins 2 & 3	Pins 1 & 2	Pins 2 & 3	Pins 2 & 3	Pins 2 & 3
í300h		Pins 2 & 3	Pins 2 & 3	Pins 1 & 2	Pins 1 & 2	Pins 1 & 2
320h		Pins 2 & 3	Pins 2 & 3	Pins 1 & 2	Pins 1 & 2	Pins 2 & 3
340h		Pins 2 & 3	Pins 2 & 3	Pins 1 & 2	Pins 2 & 3	Pins 1 & 2
360h		Pins 2 & 3	Pins 2 & 3	Pins 1 & 2	Pins 2 & 3	Pins 2 & 3
380h		Pins 2 & 3	Pins 2 & 3	Pins 2 & 3	Pins 1 & 2	Pins 1 & 2
3A0h		Pins 2 & 3	Pins 2 & 3	Pins 2 & 3	Pins 1 & 2	Pins 2 & 3
3C0h		Pins 2 & 3	Pins 2 & 3	Pins 2 & 3	Pins 2 & 3	Pins 1 & 2
3E0h		Pins 2 & 3	Pins 2 & 3	Pins 2 & 3	Pins 2 & 3	Pins 2 & 3
Note:       Pins designated should be in the closed position.

Documents / Resources

The Retro Web DE-100TP D-LINK Network Interface Card [pdf] Owner's Manual PC, XT, AT, DE-100TP D-LINK Network Interface Card, DE-100TP D-LINK, DE-100TP, D-LINK, DE-100TP Network Interface Card, D-LINK Network Interface Card, Network Interface Card, Card, Network Card, Interface Card

References

• User Manual