Aiwa Prodigy Clear Wireless Earbuds

What's Included

The package contains:

• AI1015 Earphones and Charging Case
• Silicone Eartips (Sizes S, M, L)
• USB-C Cable

A Closer Look

Charging Case:

• Charging Port: Located on the case for charging.
• LED Indicator: Shows charging status.

Earphones:

• LED Indicator: Indicates status like pairing.
• Multi-function button (Touch Control): For various controls.

Charging

Charging the Earphones

Place the earphones in the charging case to charge. The case's LED indicator will turn solid Blue when charging and turn OFF when charging is complete.

Charging the Case

Connect the included USB-C cable to the charging port on the case and the other end to a USB port on a computer or wall adapter. The charging case LED indicator will blink RED while charging and flash solid RED when charging is complete.

Charging Case LED Indicator:

• Case Charging: Red (blinking)
• Case Charged: Red (solid)
• Earbuds Charging: Blue (solid)
• Earbuds Charged: White (solid)

Powering On/Off

Remove earphones from the case to automatically turn ON. Place them back in the case to automatically turn OFF.

Note: If earphones are out of the case, place them back and remove again to turn ON.

Bluetooth Pairing

Remove earphones from the case; they will power ON and enter pairing mode. One earphone will flash red and blue, while the other stops flashing.

To pair:

1. Go to your phone's Bluetooth settings.
2. Ensure Bluetooth is turned ON.
3. Connect to the device listed as "AIWA Prodigy Clear."

Once paired, both earphones' LED indicators will stop flashing. After initial setup, earphones will automatically re-connect when removed from the charging case.

Using Your Earphones

Left Earphone Controls:

• Play/Pause: Press once
• Previous Track: Press and hold
• Volume +: Double Press
• Voice Assistant: Triple Press
• Answer Call: Press once (during incoming call)
• End Call: Press once
• Reject Call: Press and hold for 2 seconds
• Power OFF: Press and hold for 3 seconds

Right Earphone Controls:

• Play/Pause: Press once
• Next Track: Press and hold
• Volume -: Double Press
• Voice Assistant: Triple Press
• Answer Call: Press once (during incoming call)
• End Call: Press once
• Reject Call: Press and hold for 2 seconds
• Power OFF: Press and hold for 3 seconds

Note: Each earphone can be used independently if the other is turned OFF and connected via Bluetooth.

Specifications

• Driver Diameter: 13mm
• Frequency Response: 20-20kHz
• Impedance: 32ohm
• Bluetooth version: v5.3
• Transmission Distance: 10m
• Playtime: 3-4 Hours **
• Battery capacity (Earbuds): 30mAh
• Battery capacity (Case): 150mAh
• Charging input: DC 5V 1A (max)
• Charging type: Type-C

**Applicable at 50% of maximum volume. Results will be lower at higher volumes.

Safety Precautions

Follow basic safety precautions when using your earphones:

1. Read all instructions before use.
2. Do not use near water or on wet surfaces.
3. Clean only with a clean cloth.
4. Keep away from children; contains small parts that pose a choking hazard. Parental supervision is advised.
5. Do not expose to excessive heat or fire.
6. Do not expose to temperatures above 100°F (38°C); keep out of direct sunlight.
7. Do not attempt self-repair; contact a qualified service center.
8. Do not drop, crush, or expose to excessive physical force.
9. Not intended for commercial use.
10. Ensure charging cables are well-ventilated during charging and kept away from flammable materials.

Maintenance and Care

• Clean with a soft cloth or paper towel. Avoid harsh chemicals or detergents. Ensure earphones are dry before charging.
• Store in a cool, dry place when not in use.
• Avoid tugging or yanking cables while connected. Connect and disconnect carefully.
• Do not expose to extreme temperatures (hot or cold).
• Recycle or dispose of earphones according to local municipality laws. Contact local recycling facilities or the manufacturer for more information.

FCC Statement

FCC ID: 2AL9B-AI1015

Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation.

If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.

This device and its antenna(s) must not be co-located or operation in conjunction with any other antenna or transmitter.

Radiation Exposure Statement: The device has been evaluated to meet general RF exposure requirement in portable exposure condition without restriction.

Warranty

This warranty covers the original consumer purchaser only and is not transferable.

This warranty covers products that fail to function properly UNDER NORMAL USAGE, due to defects in material or workmanship. Your product will be repaired or replaced at no charge for parts or labor for a period of one year.

What Is Not Covered By Warranty

Damages or malfunctions not resulting from defects in material or workmanship, and damages or malfunctions from other than normal use, including but limited to, repair by unauthorized parties, tampering, modification, or accident.

To Obtain Warranty Service and Troubleshooting Information:

Call (877) 397-8200 or visit our website at www.aiwa.co.

To receive warranty service, along with the name and address of an authorized product service center, the original consumer purchaser must contact Aiwa for problem determination and service procedures. Proof of purchase in the form of a bill of sale or receipted invoice, evidencing that the product is within the applicable warranty period(s), MUST be presented to obtain the requested service. It is your responsibility to properly package and send any defective products along with a dated copy of proof of purchase, a written explanation of the problem, and a valid return address of the authorized service center at your expense. Do not include any other items or accessories with the defective product. Any products received by the authorized service center that are not covered by warranty will be returned unrepaired.