Elecrow ESP32 AI Camera Development Board Vision Sensor Board

Қисмҳои дастгоҳ

1. Сарлавҳаи баландгӯяк
2. Нури RGB
3. Тугмаи Ал
4. МИК
5. Сарлавҳаи UART
6. Ковокии корти TF
7. Камера
8. Нурҳои ёрирасон
9. Тугмаи Reset
10. Маърузачй
11. Порти Type-C
12. Нури барқ
13. Нури батарея
14. BAT Header

Дастури зуд

• Al Button:
  • In “Al Voice” mode, click to toggle the “Standby/Listening” status.
• Калиди аз нав танзимкунии:
  • Single-click to reboot after firmware flashing failure or device malfunction.
• Нури барқ:
  • The red LED is on steadily when powered.
• Нури батарея:
  • When powered by the battery, the red light stays on while charging, and the green light stays on when fully charged.

Ҷуфткунии шабака

1. Plug in the Type-C cable to power on.
2. If you want to use the “Al Online” feature, you need to network pair and register the Al Agent first.
3. Open your phone/computer’s WiFi list, click on “Al_Camera_XXXX” to enter WiFi pairing mode.
   • Агар webpage does not open automatically, please visit 192.168.4.1 in your browser.
4. Choose an available 2.4GHz WiFi, enter the WiFi password, and click “Save Configuration”.
   • You can see your Wifi in “WiFi Network”.
   • Шарҳ: If you want to clear your network, open the “Settings” app, then open the “Configure Network”, and click “RECONFIGURE”.
5. Open the “Al Online” app, then open a browser and go to https://portal.thinknode.cc/ to access the Al Hub interface. If this is your first time logging in, you need to click the “Create Account” button to create an account.
6. After the account is successfully created and logged in, you will receive a 5000-point reward.
7. Click the “Al Hub” button to start “Add Agent”.
8. Click “Add Agent” and give your Al Agent a name.
9. Click “Manage devices (0)”, then click “Add Device”, enter the verification code, and confirm.
10. After completing “Add Device”, you can configure the character.
11. If you want to browse “Historical conversations”, you need to first enable “Local Short-term Memory” and save.
    • Шарҳ: If your 5000 points are used up, you need to click “Recharge” to purchase a plan that will allow you to regain points.

Мушаххасоти асосӣ

• Номи маҳсулот: Al Camera Module
• Назоратчии асосӣ ESP32-S3R8
• Намоиш 1.83-inch TFT-LCD Touch Screen
• Пикселҳо 2 МП
• Бесимӣ WiFi & Bluetooth 5.0
• Флеш 16 МБ
• Ковокии корти TF Дастгирии то 128GB
• Интерфейс UART Interface. IC Pad
• Вуруд 5В/1А
• Андозаҳо 56.05*44.5*18.6мм
• Ҳарорати корӣ -20°С то 65°С

Ҳуҷҷатҳо / Сарчашмаҳо

Elecrow ESP32 AI Camera Development Board Vision Sensor Board [pdf] Дастури корбар ESP32 AI Camera Development Board Vision Sensor Board, ESP32, AI Camera Development Board Vision Sensor Board, AI Camera Development Board Vision Sensor Board, AI Camera Development Board, Camera Development Board, Vision Sensor Board, Sensor Board

Иқтибосҳо

• Дастури корбар