Infrared Thermometer User Guide
Model: K3
Introduction
Specification
- Accuracy: +0.2 degrees (34 45 C), place it in the operating environment for 30 minutes before use)
- Abnormal automatic alarm: flashing +“Di Di” sound
- Automatic measurement: measuring distance 5cm∼10cm
- Screen: Digital display
- Charging method: USB charging or battery(18650 Li-ion).
- Install method: nail hook, double-sided adhesive sticking, bracket fixing
- Environment temperature: 10ºC∼40ºC (Recommended 15ºC∼35ºC )
- Infrared measuring range: 0∼50ºC
- Response time: 5s
- Input: DC 5V
- Weight: 350g
- Dimensions: 170”115”140mm
- Standby: About one week
- Counting capacity: 999
Status Description
- Standby: The red dot in the bottom of the display lights up in (Fig. 1)
- Insufficient power: The horizontal bar lights up in the middle of the (Fig. 2)
- Normal temperature: Flashing green lights and alarm ‘Di’. (Fig. 3)
- Abnormal temperature: Flashing red lights and alarm ‘Di Di’.(Fig. 4)
- Default (bod: object mode)
’Lo’: Ultra-low temperature alarm. (Fig.5)
‘HI’: Ultra-high temperature alarm. (Fig. 6)
Operation Instruction
- Temperature measurement: Front of the thermometer and approach it within 5-10 cm. (Fig. 7)
- Mode switching: There is a small hole on the back of the device (Fig. 8). You can use a 3mm diameter screwdriver to insert the hole and then press the button
(1)Temperature unit: Press ’mode switch hole’ then select ’C’ or ’F’ (Fig.9, 10) C: Celsius F: Fahrenheit
(2) Mode: Long press mode switch hole for 3 seconds to switch the temperature measurement mode (Sur: surface mode, bod’ object mode, Cou: counting mode)
- Install and replace the battery
(1)Remove three screws
(2)Open the back base and install 18650 Li-battery
- Install method
Shenzhen Qiangwei Electronic Co., Ltd
Add: 4F, Building 3, Xialingpai Industrial Zone, Dalang
Subdistrict, Longhua District, Shenzhen, China
Email: Qwdz.aftersaIes@gmail.com
Made in China
Documents / Resources
 |
TESTACY Infrared Thermometer [pdf] User Guide Infrared Thermometer |
