TELTONIKA RUTX09 LTE-logoNetworks
Quick Start Guide v2.3
Wiki knowledge base
https://wiki.teltonika-networks.com/

TELTONIKA RUTX09 LTE-A CAT6 Cellular IoT Dual SIM Route-QRrhttps://wiki.teltonika-networks.com/

TELTONIKA RUTX09 LTE-A CAT6 Cellular IoT Dual SIM Router-icon

FRONT VIEWTELTONIKA RUTX09 LTE-A CAT6 Cellular IoT Dual SIM Router-

BACK VIEW
TELTONIKA RUTX09 LTE-A CAT6 Cellular IoT Dual SIM Router-2

POWER SOCKET PINOUT

TELTONIKA RUTX09 LTE-A CAT6 Cellular IoT Dual SIM Router-power

HARDWARE INSTALLATION

  1.  Pull out the SIM needle from the front panel of the router.
  2. Push the SIM holder button with the SIM needle.
  3.  Pull out the SIM holder.
  4. Insert your SIM card into the SIM holder.
  5. Slide the SIM holder back into the router.
  6. Attach all antennas.
  7. Connect the power adapter to the socket on the front of the device. Then plug the other end of the power adapter into a power outlet.
  8. Connect to the device via an Ethernet cable connected to the LAN port.

 

TELTONIKA RUTX09 LTE-A CAT6 Cellular IoT Dual SIM Router-HARDWARE

LOGIN TO DEVICE

  1. To enter the router’s Web interface (WebUI), type http://192.168.1.1 into the URL field of your Internet browser.
  2. Use login information shown in image A when prompted for authentication (image B). To maximize the cellular performance try adjusting the antennas or changing the location of your device to achieve the best signal conditions.

B.

MOBILE

TELTONIKA TRB145 4G LTE RS485 Gateway - NEt icon-65 dBm

Data connection

Connected

State

Registered (homed OPERATOR; 4G (LTE)

SIM card slot In use

Ready

Bytes received/sent

 348.7 KB / 223.5 KB

TECHNICAL INFORMATION

Radio specifications

RF technologies 3G, 4G, GNSS
Max RF power 24 dBm@WCDMA, 23 dBm@LTE

Bundled accessories specifications*

Power adapter Input: 0.4A@100-240VAC, Output: 9VDC, 0.5A, 4-pin plug
Mobile antenna 698-960/1710-2690 MHz, 50 0, VSWR<2, gain** 2 dBi, omnidirectional, SMA male connector
GNSS antenna 1575.42~1602 MHz, 2.2~5 VDC, VSWR<1.5, active total gain** 28 dB (typ.), RHCP polarization, SMA male connector

*Order code dependent.
**Higher gain antenna can be connected to compensate for cable attenuation when a cable is used. The user is responsible for compliance with the legal regulations.

SAFETY INFORMATION

Hereby, TELTONIKA declares that this RUTX09 is in compliance with the essential requirements and other relevant provisions of  Directive CE/RED.
The full text of the EU declaration of conformity is available at the following
internet address: https://wiki.teltonika-networks.com/view/RUTX09_CE/RED
Instruction Manual: Connect the power adapter to turn on the device. Open 192.168.1.1 in your web browser to configure it. More information on
https://wiki.teltonika-networks.com/

For more information visit www.teltonika-networks.com
TELTONIKA TRB145 4G LTE RS485 Gateway - Drisbin iconThis sign means that all used electronic and electric equipment should not be mixed with general household waste.
TELTONIKA TRB145 4G LTE RS485 Gateway - CE iconThis sign means that the product meets the requirements of the applicable EU directives.
www.teltonika-networks.com
©2020 Teltonika

Documents / Resources

TELTONIKA RUTX09 LTE-A CAT6 Cellular IoT Dual SIM Router [pdf] User Guide
RUTX09, LTE-A CAT6 Cellular IoT Dual SIM Router

References

Leave a comment

Your email address will not be published. Required fields are marked *