Telemart A9 MINI Camera Instruction Manual

Smart camera
Product model：A9
Instruction Manual

A9 MINI Camera

Download and Install the APP
Using WeChat/browser, etc. , scan the QR code to download and install the APP;

https://www.xcthings.com/html/app/appCollection.html

APP Connection

1. Open the APP, register and log in;
2. Open the mobile phone settings to connect to 2.4G WiFi(wireless fidelity) and turn on the mobile phone Bluetooth;
3. Enter the distribution network mode
   a. After powering on the device, press and hold the reset button for 5 seconds until the blue finger The indicator blinks quickly to enter the distribution mode. Bluetooth distribution network: Click “Add Device” in APP to automatically scan devices until the device ” is scanned (FIG.1), click “Bind Now” corresponding device and click “Next” (FIG. 2). After adding the successful blue indicator lights on, you can customize the device name (FIG.3), which means successful addition.

* If the device cannot be added for a long time, long press the MODE key for 5 seconds to re-enter the distribution network mode
AP Hotspot: Turn on wifi Settings in your phone’s Settings Select a name starting with LLM_ and click Enter
Password :12345678 (Figure 4) and connect, the connection is successful Open the APP (Figure 5) and click to view the real-time connection Live video

Matters Needing Attention
AP Hotspot::

1. Unable to remotely monitor video footage. Every time you need to watch, your phone is about 10 meters closer to the camera (open and unobstructed)
2. Connect to LLM_ in the Wifi and then open the APP to watch
3. During the connection of the camera’s WiFi, it is normal to not be able to access the internet normally. Disconnect the WiFi and it can be restored

Bluetooth distribution network:

1. The camera distance from the router Wifi shall not exceed 5meters;
2. Wifi with a 5G name cannot be used;
3. Try not to be close to the metal door installation (it will affect the Wifi signal to shorten the connection distance);
4. Ensure that the camera is connected to the charging power supply;
5. When the installation is completed, please remove the lens protective film before use.
6. Output voltage：DC5V

FCC Statement

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.

Caution: Any changes or modifications to this device not explicitly approved by manufacturer could void your authority to operate this equipment.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
RF Exposure Information
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with minimum distance 20cm between the radiator and your body.