INSTRUCTION GUIDE
400564
ORIGINAL INSTRUCTION MANUAL
RETAIN FOR FUTURE REFERENCE
PARTS LIST
HOW TO OPEN THE SAFE
Step1: Take off the cover,then insert the emergency key and turn to the left.
Step2: Turn the knob to the right,then open the door.
HOW TO SET USER CODE
Step1: When door is open,open the battery compartment,and insert batteries.
User code: push the Reset button.You can input user code (from 3-8 digits)within 15 seconds.Then press “A” or “B” confirm it.
Master code: with the door open,press “0” two times press the reset button and input your master codes(3-8digits).Press “A” or “B” to confirm it.
INSTALLING THE SAFE
Step1: Place safe against the wall
Step2: Mark where holes need to the drilled.
Step3: Drill holes
Step4: Place expansion bolts in holes.
Step5: Align holes in safe with expansion bolts on wall. Place screws and tighten.
Correct Disposal of this product
This marking indicates that this product should not be disposed with other household wastes throughout the EU. To prevent possible harm to the environment or human health from uncontrolled waste disposal, recycle it responsibly to promote the sustainable reuse of material resources. To return your used device, please use the return and collection systems or contact the retailer where the product was purchased. They can take this product for environmental safe recycling.
NOTE
PLEASE DO NOT LEAVE YOUR EMERGENCY KEY IN YOUR SAFE
tectake GmbH,
Tauberweg 41, D-97999 Igersheim, Germany
Please note that the safe box default password is 159 and the user code will recover to default password in no power situation over 30 minutes.
TecTake GmbH
Tauberweg 41
97999 Igersheim
Telefon: +49 7931 991 920
E-Mail: verkauf@tectake.de
TecTake Ltd
18 Soho Square
London W1D 3QL
United Kingdom
Telephone: +44 203 488 4565
mail@tectake.co.uk
Documents / Resources
 |
TecTake 400566 Double Bolt Locking System [pdf] Installation Guide 400566, 400566 Double Bolt Locking System, 400566, Double Bolt Locking System, Bolt Locking System, Locking System, System |